Read Sharp LL-193 (serv.man2) Service Manual online
LL-193A/LL-193G
CONNECTION, ADJUSTMENT, OPERATION, AND FUNCTION
2 – 3
2. INSTALLING/REMOVING THE BASE
Caution:
• Be careful not to allow your fingers to be pinched.
• Be careful not to touch the LCD panel when you install/remove the
base. The LCD panel used in this monitor is made of glass. Pressure
from hands on the LCD panel could cause damage.
from hands on the LCD panel could cause damage.
• Check that the base is firmly installed before use. If the installation is
not performed correctly, the monitor may fall down or the base may
drop.
A. Installing the base
[LL-193A]
1.
Place the base on a flat surface, such as a desktop, and insert the
stand carefully.
Insert the stand until it clicks.
Insert the stand until it clicks.
[LL-193G]
Caution: Do not remove the sticker and pin before completing the base
installation.
Otherwise, the stand may suddenly extend, causing an injury.
Otherwise, the stand may suddenly extend, causing an injury.
1.
Place the base on a flat surface, such as a desktop, and insert the
stand carefully.
Insert the stand until it clicks.
2. Remove the sticker and pin from the stand.
Caution: • Be sure to adjust the height after removing the pin from the
stand.
• You are advised to retain the sticker and pin in case the
monitor needs to be transported.
B. Removing the base (when storing the monitor)
[LL-193A]
1. Spread out a soft cloth on a flat surface. Being careful not to dam-
age the monitor, gently lay the monitor on it display-side down.
2. Pinch the four levers inward at the back bottom of the base while
pulling the base toward you.
[LL-193G]
1. Adjust the stand to its shortest height.
2. Install the pin back in the stand (refer to the illustration above for the
position to be installed).
3. Spread out a soft cloth on a flat surface. Being careful not to dam-
age the monitor, gently lay the monitor on it display-side down.
4. Pinch the four levers inward at the back bottom of the base while
pulling the base toward you.
Base
Stand
Base
Stand
Sticker
Sticker
Pin
Soft cloth
Soft cloth
Click on the first or last page to see other LL-193 (serv.man2) service manuals if exist.