LL-172G - Sharp Monitor Service Manual (repair manual). Page 6

LL-172A-W/B/LL-172G-W/B

CONNECTION, ADJUSTMENT, OPERATION, AND FUNCTIONS

2 – 1

■

Connect the accessory analog signal cable to the analog RGB output

terminal of the computer.

• Paying attention to connector direction, firmly insert the signal cable

vertically into the connector, and then tighten the screws at both

sides.

■

Connect the accessory analog signal cable, or separately-sold analog

signal cable (model name: NL-C02E) to the analog RGB output terminal

of the computer.

• Connect the accessory analog signal cable to the analog RGB input

terminal (INPUT-1). 

• Connect the separately-sold analog signal cable (model name: NL-

C02E) to the DVI-I input terminal (INPUT-2).

•  Paying attention to connector direction, firmly insert the signal cable ver-

tically into the connector, and then tighten the screws at both sides.

If connecting to a D-sub15 pin 2 row Apple Power Macintosh, attach a

Macintosh conversion adapter (commercially available) to the analog

signal cable.

Note:

•  If connecting to the Sun Ultra series, a conversion adapter (com-

mercially available) may be required.

■

Connect the accessory digital signal cable to the digital RGB output ter-

minal of the computer.

• The monitor has an input for connecting to a computer with a DVI-

compatible output connector (DVI-D24 pin or DVI-I29 pin) and SXGA

output capability. (Depending on the type of computer to be con-

nected, the display may not work correctly.)

• Paying attention to connector direction, firmly insert the signal cable

vertically into the connector, and then tighten the screws at both
sides.

Set the monitor as follows when establishing a digital connection with a
Power Mac using an ADC-DVI adapter made by Belkin. (Operation has
been checked with the Power Mac G4 M7627J/A.)

•  Perform settings with the Power Mac power supply off.

1. After connecting the power cord, turn on the monitor's main power.

2. Press the [

e

] button and [

d

] button simultaneously, and while doing

this press the power button (i.e. turn the power on).

3. Set to [ON] with the [

e

] [

d

] buttons.

•  Do not set to [ON] if you are not using a Belkin ADC-DVI adapter,

as this may result in incorrect display.

4. Press the [MENU] button.

This completes setting.

Analog RGB terminal
(Mini D-sub 15 pin, 3 row)

Analog signal cable

Analog RGB terminal
(INPUT 1)

Analog signal cable

Analog RGB output
terminal

DVI-I input terminal
(INPUT-2)

Macintosh conversion adapter

DVI-I input terminal
(INPUT-2)

Digital signal cable

Digital RGB output terminal

INPUT-2

OK        [MENU]

MAC DIGITAL

OFF       ON