Read Sharp LL-172G Service Manual online
LL-172A-W/B/LL-172G-W/B
CONNECTION, ADJUSTMENT, OPERATION, AND FUNCTIONS
2 – 10
6. IF THE FOLLOWING WINDOW IS DISPLAYED,
it is supposed that:
1. The writing board is not connected properly to the PC
2. The writing board is already connected to the monitor.
Check the connection, press [OK] and then [Next].
7. AFTER MAKING SURE THE FOLLOWING WIN-
DOW IS DISPLAYED, CONNECT THE MONITOR
TO THE WRITING BOARD.
TO THE WRITING BOARD.
Check the model name. (The following screen shows the case of
the LL-172A-B.)
the LL-172A-B.)
[Setting up the monitor side]
1. Connect the RGB cable (172A,172G) or DVDH (172G) cable to
the EDID writing board.
2. Turn on the main [power supply] switch.
3. Press the Front [POWER] key to turn on and wait until the mes-
sage "No input signal" appears on screen.
8. TYPE THE SERIAL NUMBER USING THE KEYBOARD
AND CLICK NEXT.
9. TYPE THE SERIAL NUMBER AND CLICK NEXT.
THE FOLLOWING SCREEN IS DISPLAYED.
On this screen, EDID is written and verified. If the operation stops half-
way, it indicates that the connection is not correct. Check for proper
connection.
[In the case of LL-172A-W, LL-172A-B]
way, it indicates that the connection is not correct. Check for proper
connection.
[In the case of LL-172A-W, LL-172A-B]
[In the case of LL-172G-W, LL-172G-B]
If writing is finished, the window at step (7) appears. Connect the next
monitor to the writing board.
Repeat the writing procedure from step 7 to write EDID to the next
monitor.
monitor to the writing board.
Repeat the writing procedure from step 7 to write EDID to the next
monitor.
10.IF AN ERROR OCCURS DURING WRITING OR
VERIFYING:
If an error occurs during writing or verifying, the following window
will appear.
When Retry is pressed, writing of EDID and verification will be tried
again. Usually check for proper connection of the cable and board-
before pressing Retry.
If the error persists, press Cancel. The screen changes to the next
one. Note that the EDID is not yet written properly.
will appear.
When Retry is pressed, writing of EDID and verification will be tried
again. Usually check for proper connection of the cable and board-
before pressing Retry.
If the error persists, press Cancel. The screen changes to the next
one. Note that the EDID is not yet written properly.
11. IF WRITING OF EDID IS COMPLETED PROPERLY OR
IF THE CANCEL BUTTON IS PRESSED ON THE EDID
ERROR SCREEN, THE SCREEN WILL RETURN TO
THE BARCODE READ SCREEN AT STEP (7).
NOW, YOU CAN WRITE EDID FOR OTHER SETS.
ERROR SCREEN, THE SCREEN WILL RETURN TO
THE BARCODE READ SCREEN AT STEP (7).
NOW, YOU CAN WRITE EDID FOR OTHER SETS.
Click on the first or last page to see other LL-172G service manuals if exist.