Read Sharp R-962M Service Manual online
R-962M - 18
MONITORED LATCH SWITCH, DOOR SWITCH AND MONITOR SWITCH REMOVAL
1. CARRY OUT 3D CHECKS.
2. Remove the control panel assembly referring to
2. Remove the control panel assembly referring to
"CONTROL PANEL REMOVAL".
3. Disconnect the all leads from the switches.
4. Remove each one (1) screw holding the upper latch hook
4. Remove each one (1) screw holding the upper latch hook
and lower latch hook to the oven cavity.
5. Remove the upper and lower latch hooks from the oven
cavity.
6. Push the monitored latch switch downwards with pushing
the retaining tab.
7. Push the monitor switch or stop switch rightwards with
pushing the retaining tab.
CAUTION: WHEN REMOVING THE SWITCH, DO NOT
BREAK THE TABS OF THE LATCH HOOKS.
Figure C-6. Switches
COMPONENT REPLACEMENT AND ADJUSTMENT
REPLACEMENT
1. CARRY OUT 3D CHECKS
2. Remove five (5) screws holding the upper and lower oven
2. Remove five (5) screws holding the upper and lower oven
hinge to the oven cavity.
3. Now, the lower oven hinge is free.
4. Separate the door assembly and upper oven hinge. Door
4. Separate the door assembly and upper oven hinge. Door
assembly is now free.
5. Re-install lower oven hinge to the new door assembly.
6. On re-installing new door assembly, secure the upper
6. On re-installing new door assembly, secure the upper
and lower oven hinges with the five (5) mounting screws
to the oven cavity. Make sure the door is parallel with
bottom line of the oven face plate and the latch head pass
through the latch holes correctly.
to the oven cavity. Make sure the door is parallel with
bottom line of the oven face plate and the latch head pass
through the latch holes correctly.
7. CARRY OUT 4R CHECKS
Note: After any service to the door, the approved microwave
Note: After any service to the door, the approved microwave
survey meter should be used to assure in compliance
with proper microwave radiation standards. (Refer to
Microwave Measurement Procedure.)
with proper microwave radiation standards. (Refer to
Microwave Measurement Procedure.)
Figure C-8. Door Assembly Replacement and Adjustment
CHOKE COVER REMOVAL
1. Insert an iron plate (thickness of about 0.5mm) or flat type
screw driver to the gap between the choke cover and
door panel as shown in figure C-9 to free the engaging
part. The protect sheet may be used so as not to damage
the door panel.
door panel as shown in figure C-9 to free the engaging
part. The protect sheet may be used so as not to damage
the door panel.
2. Lift up the choke cover, now choke cove is free.
FLAT TYPE
SCREW-DRIVER
SCREW-DRIVER
PROTECT BY TAPE
CHOKE
COVER
COVER
DOOR
PANEL
PANEL
DOOR
Figure C-9. Choke Cover Removal
RE-INSTALL
DOOR
ASSEMBLY
ASSEMBLY
SCREWS
SCREWS
UPPER
OVEN HINGE
OVEN HINGE
OUTER CASE
CABINET
CABINET
LOWER
OVEN HINGE
OVEN HINGE
LATCH
HEADS
HEADS
SW3 Monitor
switch
SW1 Monitored
latch switch
latch switch
SW2 Stop
switch
switch
Tab
Tab
Tab
Click on the first or last page to see other R-962M service manuals if exist.