R-962M (serv.man2) - Sharp Home Appliance User Guide / Operation Manual. Page 8

6

Your oven comes set for an “energy save” mode. When “energy save” mode is “on”, the microwave display
will show “.0” instead of the time of day. If you do nothing for 2 minutes after the preceding operation, i.e.
plugging in or at the end of cooking, the power will go off automatically and the display will show “OVEN IN
ENERGY SAVE MODE” just before the oven is in “energy save” mode. The energy consumption of the oven will
nearly equal zero in the “energy save” mode. To restore the power, open and then close the door.
“Energy save” mode will remain “on” until you set the clock.

To set the energy save mode:

3. Press the START/AUTO

MINUTE key once.

1. Press the AUTO START/CLOCK

key once.

2. Press the AUTO

START/CLOCK  key again.

The display will show:

The display will show:

1. Plug in the oven. Nothing will appear on the diaplay

at this time.

2. Open the door. The display will flash the message

shown opposite.

3. Close the door. The oven display will show “.0”. If

you set the clock, energy save mode will be off. If you

keep energy save mode go to step 5.

4. Set the clock, refer to page 7.

5. Heat the oven using the convection and grill without

food for 20 minutes. (For operation, see NOTES on

pages 10 and 11).

Use the STOP/CLEAR key to:
1. Erase a mistake during programming.
2. Stop the oven temporarily during cooking.
3. Cancel a programme during cooking, press twice.

STOP/CLEAR key

R-962M O/M FINAL  28/6/99  12:30 pm  Page 6