R-959SLMA (serv.man11). Component Replacement And Adjustment Procedure - Sharp Home Appliance Service Manual (repair manual). Page 7

R959(SL)MA

11 – 7

1. Re-install the front door glass to the door frame by sliding it left-

wards.

2. Reinstall the handle cover to the door frame with one (1) screw.

3. Re-install the door handle and the two (2) handle bases to the door

frame with two (2) screws.

4. Re-install the latch spring to the latch head. Re-install the latch

spring to the door frame. Re-install latch head to door frame.

5. Re-install door panel to door frame.

6. Hold the door panel to the door frame with eight (8) screws.

7. Re-install choke cover to door panel by clipping into position.

8. Locate door panel hinge pins into cavity hinge location holes.

9. Re-install the door stopper to the chock cover.

NOTE: After any service to the door;

1) Make sure that the monitor switch, monitored latch

2) An approved microwave survey meter should be used

1. Door latch heads smoothly catch latch hook through latch holes

and that latch head goes through centre of latch hole.

2. Deviation of door alignment from horizontal line of cavity face plate

is to be less than 1.0mm.

3. Door is positioned with its face pressed toward cavity face plate.

4. Check for microwave leakage around door with an approved micro-

wave survey meter. (Refer to Microwave Measurement Procedure.)

NOTE: The door on a microwave oven is designed to act as an elec-

tronic seal preventing the leakage of microwave energy from
oven cavity during cook cycle. This function does not require
that door be air-tight, moisture (condensation)-tight or light-
tight. Therefore, occasional appearance of moisture, light or
sensing of gentle warm air movement around oven door is not
abnormal and do not of themselves, indicate a leakage of
microwave energy from oven cavity.

           Figure C-9. Door Replacement

Upper oven hinge

Lower oven
hinge

Lower

oven

hinge

Pin

Door
assembly

Pin