Read Sharp R-959SLMA (serv.man11) Service Manual online
R959(SL)MA
11 – 5
[12] OVEN LAMP SOCKET REMOVAL
1. CARRY OUT 3D CHECKS.
2. Remove the wire leads as Positive lock
connector removal above.
3. Lift up the oven lamp from its retaining clips by pushing the tab of
the air intake duct.
4. Now, the oven lamp is free.
Figure C-4. Oven lamp
[13] POWER SUPPLY CORD REPLACEMENT
1. REMOVAL
1. CARRY OUT 3D CHECKS.
2. Remove the one (1) screw holding the green/yellow wire to the
back plate.
3. Disconnect the leads of the power supply cord from the noise filter,
referring to the Figure C-5(a).
4. Release the power supply cord from the rear cabinet.
5. Now, the power supply cord is free.
Figure C-5 (a) Replacement of Power Supply Cord
2. REINSTALL
1. Insert the moulding cord stopper of power supply cord into the
square hole of the power angle, referring to the Figure C-5(b).
2. Install the earth wire lead of power supply cord to the back plate
with one (1) screw and tight the screw.
3. Connect the brown and blue wire leads of power supply cord to the
noise filter correctly, referring to the Pictorial Diagram.
Figure C-5(b). Power Supply Cord Replacement
[14] GRILL HEATING ELEMENTS REMOVAL
1. CARRY OUT 3D CHECKS.
2. Disconnect wire leads from the thermal cut-out (GRILL).
3. Remove the two (2)screws holding the two (2) terminals of the main
wire harness to the two (2) grill heating elements.
4. Remove the one (1) screw holding the exhaust duct to the oven
cavity top plate.
5. Remove the exhaust duct from the oven cavity top plate.
6. By pushing the two (2) tabs holding the grill reflector to the oven
cavity top plate, slide the grill reflector toward the magnetron. And
then lift up the grill reflector and remove it.
then lift up the grill reflector and remove it.
7. Remove the one (1) screw holding the grill heater angle to the grill
heater reflector.
8. Straighten the two (2) tabs of the grill heater angle and remove the
grill heater angle from the grill reflector.
9. Remove the two (2) screws holding the earth plate to the two (2)
grill heating elements.
10.Remove the two (2) grill heating elements from the grill reflector.
11.Now, the grill heating elements are free.
[15] MONITORED LATCH SWITCH, MONITOR SWITCH AND STOP SWITCH REMOVAL
1. CARRY OUT 3D CHECKS.
2. Remove the control panel assembly referring to “CONTROL
PANEL ASSEMBLY REMOVAL”.
3. Disconnect the leads from all switches.
4. Remove the two (2) screws holding the latch hook to the oven cav-
ity.
5. Remove the latch hook.
6. Remove the switch(es) from the latch hook by pushing the retaining
tab backwards slightly and turning the switch(es) on the post.
7. Now the switch(es) is free
Figure C-6. Switches
Lock
Socket
Bulb
Power supply
cord
cord
Back plate
Blue wire
Brown wire
Green/
Yellow wire
Yellow wire
Noise filter
WHIT
RED
F2
F1
TP
N
L
TL
Power supply cord
Back plate
Moulding cord stopper
Square hole
Stop switch
Monitor switch
Monitored
latch switch
latch switch
Tab
Post
Post
Click on the first or last page to see other R-959SLMA (serv.man11) service manuals if exist.