R-951M - Sharp Home Appliance Service Manual (repair manual). Page 14

R-951M  -  14

1. CARRY OUT 3D CHECKS.
2. Remove the control panel assembly referring to

"CONTROL PANEL REMOVAL".

3. Disconnect the all leads from the switches.
4. Remove each one (1) screw holding the upper latch

hook and lower latch hook to the oven cavity.

5. Remove the upper and lower latch hooks from the

oven cavity.

6. Push the monitored latch switch downwards with

pushing the retaining tab.

7. Push the monitor switch or stop switch rightwards with

pushing the retaining tab.

CAUTION: When removing the switch, do not break the

tabs of the latch hooks.

Monitor switch

Monitored
 latch switch

Door switch

Tab

Tab

Tab

1. CARRY OUT 3D CHECKS
2. Remove five (5) screws holding the upper and lower

oven hinge to the oven cavity.

3. Now, the lower oven hinge is free.
4. Separate the door assembly and upper oven hinge.

Door assembly is now free.

5. Re-install lower oven hinge to the new door assembly.
6. On re-installing new door assembly, secure the upper

and lower oven hinges with the five (5) mounting
screws to the oven cavity. Make sure the door is
parallel with bottom line of the oven face plate and the
latch head pass through the latch holes correctly.

7. CARRY OUT 4R CHECKS

Note: After any service to the door, the approved micro-

wave survey meter should be used to assure in
compliance with proper microwave radiation  stand-
ards. (Refer to Microwave Measurement Proce-
dure.)

RE-INSTALL

DOOR 
ASSEMBLY

SCREWS

SCREWS

UPPER
OVEN HINGE

OUTER CASE
CABINET

LOWER
OVEN HINGE

LATCH
HEADS

1. Insert an iron plate (thickness of about 0.5mm) or flat

type screw driver to the gap between the choke cover
and door panel as shown in figure C-9 to free the
engaging part. The protect sheet may be used so as
not to damage the door panel.

2. Lift up the choke cover, now choke cove is free.

FLAT TYPE
SCREW-DRIVER

PROTECT BY TAPE

CHOKE
COVER

DOOR
PANEL

DOOR