R-90GCK (serv.man21) - Sharp Home Appliance User Guide / Operation Manual. Page 6

TINSEA962WRRZ-K32 UK R90GCK

A39887,R90GCK O/M

4

4

1. Remove all packing materials including the

feature sticker (if applicable). Do not remove
the plastic film from the inside of the oven
window as this protects it from dirt. The
waveguide cover prevents food and grease
from entering the waveguide area where it
could cause damage. DO NOT REMOVE THE
WAVEGUIDE COVER.

2. The oven door will become hot during cooking.

Place oven on a secure, level surface so that the
bottom of the oven is 85cm or more above the
floor. Ensure it is strong enough to take the
oven weight, plus the heaviest item likely to be
cooked in the oven.

3. The minimum height of

free space necessary
above the top surface of
the oven is 9cm.

4. Do not place the oven where heat, moisture or

high humidity are generated, (for example,
near or above a conventional oven) or near
combustible materials (for example, curtains).
Do not block or obstruct air vent openings.
Do not place objects on top of the oven.

5. Make sure the power supply cord is undamaged

(See “ELECTRICAL CONNECTION” opposite).
Do not allow the power supply cord to
run over any hot or sharp surfaces,
such as the hot air vent area at the top
rear of the oven.

9 cm

6. The socket must be readily accessible so that it

can be easily unplugged in an emergency.

7. Do not use the oven outdoors.

BUILDING-IN-KIT.
An installation frame is available which enables the
microwave oven to be integrated within a kitchen
unit.
The microwave oven is not designed to be built
above or near a conventional oven.
SHARP recommend the use of the build in kit EBR-
90GKST, available from your SHARP dealer.
Only the use of this frame will guarantee the
quality and safety of the oven.

ELECTRICAL CONNECTION.
• Do not allow water to come into contact with the

power supply cord or plug.

• Insert the plug properly into the socket.
• Do not connect other appliances to the same

socket using an adaptor plug.

• If the power supply cord is damaged, it must be

replaced by a SHARP approved service facility
or a similarly qualified person to avoid a
hazard. 

• When removing the plug from the socket always

grip the plug, never the cord as this may
damage the power supply cord and the
connections inside the plug.

• If the plug fitted to your oven is a rewireable

type and in the event of the socket outlet in your
home not being compatible with the plug
supplied, remove the plug properly (do not cut
off). 

• If the plug fitted to your oven is a non-rewirable

type and in the event of the socket outlet in your
home not being compatible with the plug
supplied, cut-off the mains plug.

• Refit with a suitable type, observing the wiring

code given in `To replace the mains plug’ on
page 38.

UK R90GCK English Cover-P19  04.1.9 8:55 AM  Page 4