Read Sharp R-754M (serv.man2) Service Manual online
R-754M - 25
6. Release two (2) pins of door panel from two (2) holes
upper and lower oven hinges by lifting up.
7. Now, door sub assembly is free from oven cavity.
8. Remove the six (6) screws holding the door panel to the
8. Remove the six (6) screws holding the door panel to the
door frame.
9. Now, door panel is free.
10.Slide latch head upward and remove it from door
10.Slide latch head upward and remove it from door
frame, releasing latch spring from door frame and
latch head.
latch head.
11.Now, latch head and latch spring are free.
12.Remove the one (1) screw holding the glass stopper to
12.Remove the one (1) screw holding the glass stopper to
the door frame.
13.Remove the glass stopper from the door frame.
14.Slide the front door glass upwards and then right-
14.Slide the front door glass upwards and then right-
wards.
15.Remove the door glass from the door frame.
16.Remove the handle covers A and B from the door
16.Remove the handle covers A and B from the door
frame.
17.Now, the door frame is free
RE-INSTALL
1. Re-install the front door glass to the door frame as
1. Re-install the front door glass to the door frame as
follows.
1) Insert the upper edge of the front door glass into the
1) Insert the upper edge of the front door glass into the
door frame.
2) Slide the front door glass downwards into the door
frame and then leftwards.
3) Re-install the glass stopper to the door frame with
one (1) screw.
2. Re-install the handle covers A and B to the door frame.
3. Re-install the latch spring to the latch head. Re-install
3. Re-install the latch spring to the latch head. Re-install
the latch spring to the door frame. Re-install latch head
to door frame.
to door frame.
4. Fit the door panel to the door frame with six (6) screws.
5. Insert two (2) pins of door panel on two (2) holes of
5. Insert two (2) pins of door panel on two (2) holes of
upper and lower oven hinges.
6. Re-install choke cover to door panel.
Note: After any service to the door;
(A) Make sure that the monitor switch, monitored
latch switch and stop switch are operating prop-
erly.
erly.
Figure C-9. Door Replacement
Pin
Pin
Upper oven hinge
Lower
oven
hinge
oven
hinge
Lower oven
hinge
hinge
Choke cover
Door panel
Slit choke
Slit choke
COMPONENT REPLACEMENT AND ADJUSTMENT PROCEDURE
NOTE: When carrying out any repair to the door,
do not bend or warp the slit choke (tabs on
the door panel assembly) to prevent
microwave leakage.
Click on the first or last page to see other R-754M (serv.man2) service manuals if exist.