UP-X200 (serv.man9). Service Manual - Sharp EPOS Service Manual (repair manual). Page 48

UP-X200

CHARGING THE BATTERY (Explanation of options)

– 46 –

You can use the cradle charger or the battery charger for charging the battery.

When you use the optional cradle charger (UP-B01CH) for charging
battery, follow the procedure shown below.

1.

Connect the AC power cord to the AC adapter.

2.

Plug the AC adapter connector into the cradle charger.

3.

Plug the AC power cord into an AC outlet.

4.

Place the mobile terminal in the cradle charger by sliding as shown
bellow. Make sure that the terminal is fully inserted into the cradle
charger. The charge indicator on the terminal will illuminate orange
when charging begins.

Note: Please make sure that the power indicator turns green when the

mobile terminal is placed in the cradle.
If the terminal is not placed correctly, the power indicator will not light.

Charging time:

•  When the mobile terminal is OFF : approx. 3 hours

•  When the mobile terminal is ON : approx. 4.5 hours

(this varies depending on the ambient temperature and operating

conditions.)

5.

When charging has been completed, the charge indicator will turn off.
Upon completion, lift the mobile terminal from the cradle charger.

6.

Unplug the AC power cord from the AC outlet and unplug the AC
adapter connector from the cradle charger.

Note:

•  The AC power cord plug may differ in some countries.

•  Do not use the AC adapter for other equipment. This adapter is

specifically designed for the UP-X200.

•  Do not use voltages beyond the indicated power supply voltage range.

•  When the cradle charger is not in use, disconnect the AC power

cord and the AC adapter from the wall outlet for safety purposes.

•  Do not connect or disconnect the AC adapter with wet hands.

•  The AC plug must comply with the AC outlet configuration.

When using the optional battery charger (UP-P01CH) for charging the
battery, follow the procedure shown below.
You must remove the batteries from the mobile terminal for charging.
To remove and install the batteries.

Note: Only use the SHARP model EA-BL08 rechargeable battery.

1. Connect the AC power cord to the battery charger and plug the

other end into an AC outlet.

2. Insert the battery into the battery charger.

Make sure that the triangle (

b

), plus (+), and minus (-) marks on the bat-

tery are aligned correctly with those indicated on the battery charger.
The charge indicator on the battery charger will illuminate red when

charging begins.

The charging time is approximately 3 hours, and may vary depend-
ing on the ambient temperature and operating conditions.

3.

When the charging has been completed, the charge indicator will turn
off. Upon completion, remove the battery from the battery charger.

4. Unplug the AC power cord from the AC outlet and from the battery

charger.

Note:

•  The AC power cord plug may differ in some countries.

•  Do not use voltages beyond the indicated power supply voltage range.

•  When not in use, disconnect the AC power cord from the wall outlet

for safety.

•  The AC plug must be appropriate for AC outlet configuration

Routing the
AC adapter cable

AC adapter jack

Cradle
charger

AC adapter

AC power cord

To AC outlet

AC adapter connector

(UP-B01CH)

Charge
indicator

Power indicator

Battery charger
(UP-P01CH)

AC power cord

To AC outlet

Charge indicator