Read Sharp UP-5900 (serv.man7) Service Manual online
UP-5900VI
MCR UNIT: UP-E12MR2
– 7 –
12. MCR UNIT: UP-E12MR2
1) Fix the MCR ANGLE
1
to the lower cabinet with two screws
2
.
2) Connect the MCR cable
3
to the MCR connector with the cable
holder
6
, and tighter the screw
7
on the back of lower cabinet.
3) Install the ferrite Core
4
to the MCR cable and GND wire
5
.
4) Fix the earth wire
5
from the UP-E12MR2 with the screw.
5) Attach the rubber foot in Main Unit.
13. Rear display UP-I20DP
1) Remove the Display filter
1
.
2) Remove the Rear cover angle
2
from the Display filter
1
a) Remove the two Screws
3
.
3) Connect the display cable
4
to the connector: CN22 on the Main
PWB.
4) Install the Display unit
5
to the cabinet
a) Align the positioning boss
A
of the bottom cabinet with the
angle hole
A
in the display unit.
14. Pole display: UP-P20DP
1) Install the core
6
to the display cable
1
and the display earth
cable
4
.
2) Connect the Display cable
1
to the remote display connector on
the back of the set.
3) Fix the display cable
1
with the cable holder
2
, and tighten the
screw
3
on the back of bottom cabinet.
4) Fix the display earth cable
4
to the main chassis with the screw
5
.
*
Cable holder
2
.
Use the following type of cable holder supplied with the UP-P20DP.
• “3N” (large type)
2
1
3
4
6
5
7
1
2
3
1
A
4
5
A
A
2
3
1
4
6
5
Within 5cm
Click on the first or last page to see other UP-5900 (serv.man7) service manuals if exist.