Read Sharp GENERAL (serv.man24) User Guide / Operation Manual online
NetSupport Manager
125
Control Configuration – Transport Tab
Before you can connect to Clients on your network you must select and configure the
transports to use. These transport protocols must be configured in the operating system
before attempting to use them here. If any of the transports are not available to NetSupport,
the relevant groups below will be disabled.
transports to use. These transport protocols must be configured in the operating system
before attempting to use them here. If any of the transports are not available to NetSupport,
the relevant groups below will be disabled.
TCP/IP
Use TCP/IP
Check this button to enable the Control to use the TCP/IP protocol. This protocol is used with
the Internet, Local and Wide area networks. In order to connect to TCP/IP Clients you need to
specify the port number that the Client is listening on.
Check this button to enable the Control to use the TCP/IP protocol. This protocol is used with
the Internet, Local and Wide area networks. In order to connect to TCP/IP Clients you need to
specify the port number that the Client is listening on.
Click on the first or last page to see other GENERAL (serv.man24) service manuals if exist.