DOS HOSPITALITY (serv.man5). Waitermate Program Operation Manual Ver 1.05 - Sharp EPOS User Guide / Operation Manual. Page 7

Before the Waitermate is programmed for the first time check the following

1.

Power on the Waitermate, at the bottom of the screen check that the following is seen

2.

If the above is OK touch the screen and check the following is displayed

It is important that the 

A

S

@

 is on the end of the Number

If either of the above are not satisfied the Waitermate will not Function. It will need returning to be set-
up correctly.

After setting and checking the above it is now possible to load a Waitermate Terminal. This is done from
the Waitermate Control POS. From the Manager Menu select Utilities and then More.... If the
Waitermate has been correctly set in RINCS.CFG an option will appear 

A

Waitermate Loader

@

. Select

this. The application will be exited and a compiler routine will be seen running on the POS, when this
is finished you will be prompted to Switch the POS Off and then ON again using the Power Switch, at
this time an AT Keyboard must be plugged into the POS

When the POS reboots a menu will be shown with the following options :-

1.

Program Waitermate - this is used to program a New Waitermate unit or if  Lists, Keyboards
or Product texts have been changed on the POS. The On-Screen Steps should be followed.

2. 

Program Waitermate (With Default Calibration) - this is the same as above but it also sets
the default Keyboard Calibration on if the  Waitermate has had a bad Calibration carried out.
The default Calibration settings are sent to the Waitermate. It may be necessary to calibrate the
Waitermate after this operation.

3.

EXIT to POS - This option restarts the POS into the application ready for use.

N.B Please  remember to reprogram Waitermate Terminals after an Open Session after the POS
program has changed.

The System should now be ready for use.