Read Sharp XE-A301 (serv.man10) Technical Bulletin online
E
E
C
C
R
R
/
/
E
E
P
P
O
O
S
S
T
T
e
e
c
c
h
h
n
n
i
i
c
c
a
a
l
l
S
S
u
u
p
p
p
p
o
o
r
r
t
t
2
(1) Use alcohol to remove any grease from the area where the filament tape will be attached.
(2) Cut a 20-mm long piece of 19-mm wide filament tape. Attach a 5 to 10-mm long portion to the
(2) Cut a 20-mm long piece of 19-mm wide filament tape. Attach a 5 to 10-mm long portion to the
top surface, and then attach the remaining portion to the underside surface by turning down
the tape.
2. Treatment of the solenoid cable
Since the solenoid cable is drawn out from the left side of the solenoid, the cable is positioned
close to the extrusion spring. As a result, the solenoid cable may come in contact (get entangled)
with the extrusion spring if there is slack in the solenoid cable.
As a countermeasure, pull the cable tight before securing the solenoid cable to the bottom cabinet
to eliminate any slack in the cable.
Display
