Read Sharp UP-800 (serv.man17) Service Manual online
3-3
LT-1320CS
A
B
1
■ Disassembly/Assembly
This section explains how to remove all parts of the printer. When needing to replace a certain part, proceed
with the steps described below until the part in question. To assemble, reverse the order of the steps.
Steps which require special attention during assembly are marked with a black circle (
●).
q
w
C
● Removing the auto cutter unit
q Pull the hook located at the cutter base of the
q Pull the hook located at the cutter base of the
auto cutter unit in the direction of arrow A and
turn the auto cutter in the direction of arrow B.
w Remove the two attached screws from the
auto cutter unit and raise the auto cutter unit
to remove it from the main unit.
e Remove the two screws (M2.0x4) and
remove the mouse plate from the auto cutter
unit.
e
Hook
Auto cutter
Cutter base
Attached screw
Auto cutter unit
Mouse Plate
Auto cutter unit
Screw
(M2.0x4)
(M2.0x4)
● Mounting the auto cutter unit
Set the mouse plate to the auto cutter unit
and attach the auto cutter unit to the main unit
by reversing the disassembly procedure.
Click on the first or last page to see other UP-800 (serv.man17) service manuals if exist.