Read Sharp UP-600 / UP-700 (serv.man6) Handy Guide online
E
E
C
C
R
R
/
/
E
E
P
P
O
O
S
S
T
T
r
r
a
a
i
i
n
n
i
i
n
n
g
g
5. General Communications
Two standard RS232 Ports
Optional 2 Ports with ERA5RS
Optional Network Card UP-E01IN
Network Specification.
The type of network used on the UP600/700 is a LAN.
(Local Area Network)
(Local Area Network)
Transmission system
10Base-T
(10 Meg bits/sec on UTP structured cable)
Transmission Distance
Segment length max 100M
Cable Type
UTP (Unshielded Twisted Pair)
Number of connectable machines
15 for Real Time Communications
32 for general LAN specification
32 for general LAN specification
Hardware Requirements for network system.
1. Each machine must be fitted with an UP-E10IN Interface board.
2. Memory Board UP-S02MB or UP-S04MB must be fitted to the master, and
depending on the system configuration may be required in the Slave terminals.
3. A Hub will be required for a system of 3 machines or more (L80UPHUB800)
4. Cable Standard Cat-5 (Straight Through) for Hub
5. Cross over cable for machine to machine
Program Setup
The programming of the Network is almost the same as on previous models.
The only difference is setting the Terminal number and master list.
Instead of referring to the Terminal number we will refer to them as the IP Address
The first three addresses should be set as the default setting.
Click on the first or last page to see other UP-600 / UP-700 (serv.man6) service manuals if exist.