Read Sharp ORDERMAN Handy Guide online
E
E
C
C
R
R
/
/
E
E
P
P
O
O
S
S
T
T
e
e
c
c
h
h
n
n
i
i
c
c
a
a
l
l
S
S
u
u
p
p
p
p
o
o
r
r
t
t
Page 2 of 3
5. Click on Download (send). This will download the initial setting to the BS
6.
Now disconnect the cable between to PC and BS and use this cable
to connect the BS to ECR.
7.
At the ECR set the Channel Number that will be used for connection
of the cable to the Orderman and the baud rate. (DEVICE ASSIGN-
ORDERMAN) you also have to enter the Orderman ID this is the last five
digits of the Orderman Hand held terminal Serial Number example S/N
AOBO49367 this can be found by removing the battery from the OM.
ORDERMAN) you also have to enter the Orderman ID this is the last five
digits of the Orderman Hand held terminal Serial Number example S/N
AOBO49367 this can be found by removing the battery from the OM.
8.
At ECR, go to PGM/ Setting/ OM download and start to download the
data from ECR to BS.
Display will show xmit and start counting up please wait for it to finish
Display will show xmit and start counting up please wait for it to finish
If this fails, something is wrong with the BS or with the connection. Or the set
up mentioned above.
Display will show xmit and start counting up please wait for it to finish
Display will show xmit and start counting up please wait for it to finish
If this fails, something is wrong with the BS or with the connection. Or the set
up mentioned above.
9.
You will now have to get the Orderman terminal into “Extended
Menu” mode
1.
1.
Take the Hand Held Orderman, Power off the unit.
2.
While pressing on the screen, power on and keep the power on button
pressed until you can read “CALIBRATE” on the OM
3.
Release both the Power On button and the screen.
4.
Press the Power On button again, you should now be in the first service
menu. (Orderman Setup)
5.
Click on the word Don once, (if you have the Max, then click Max) and
press the Power button one more time. You are now in the second service
menu. (Extended Menu)
menu. (Extended Menu)
10.
From the Extended Menu area click the RF-Channel icon
and select the Radio Channel number, this must be the same number as
set up at point 3.
Now, click on Radio Test to see if a connection from the OM to the BS can
be established. The counter will count up, indicating connection is OK, you
can end this test at any time, by pressing the exit button.
set up at point 3.
Now, click on Radio Test to see if a connection from the OM to the BS can
be established. The counter will count up, indicating connection is OK, you
can end this test at any time, by pressing the exit button.
Click on the first or last page to see other ORDERMAN service manuals if exist.