ER-A570 (serv.man8). ERA570 Programming Manual - Sharp ECR Service Manual (repair manual). Page 48

Stop of printing reports:
The printing of all reports can be stopped by the following operation.

  Changing of Receipt switch during printing reports.
  ON 

→

 OFF or OFF 

→

 ON

Note) When the printing is stopped, the consecutive number or Z

counter don’t return to the original value.
When Z reports, Memory is not reset.
In In-line system, when Master has consolidated the data from
the satellite, ECR can stop the printing.

∗

1 X1: Daily X report

X2: Periodic X report

Z1: Daily Z report
X2: Periodic Z report

∗

2 The time interval range, PLU code, or customer code range can

be specified by entering the start and end numbers according to
the following procedure. When specifying a single time interval,
PLU code, the start number has only to be entered.

∗

3 When 2 is entered in the third digit of a job code, periodic reports

are printed.
Example: Daily general report;  job code 100

Periodic general report;  job code 200

•

An individual report is printed on the receipt and journal when the
TL key is pressed.

•

Pressing the decimal point key just after the enery of a job code
clears the corresponding data in the ECR. (Z report)
(When printing those reports for which no Z reports can be taken,
the decimal point key cannot be pressed after the entry of a job
code.)

•

When the decimal point key is not pressed after the entry of a job
code, the corresponding data is held in the ECR. (X report)

XXXXXX

All

X

Start No.

End No.

XXXXXX

 47 