Read Sharp ER-A450S (serv.man6) Service Manual online
CHAPTER 3. OP X/Z, X1/Z1,X2/Z2
MODE
MODE
The following categories of reports can be printed by the ECR.
1) OP X/Z reports (individual clerk reports)
2) X1/Z1 reports (Daily sales total X and Z reports)
3) X2/Z2 reports (Periodic total X and Z reports)
4) Flash-read reports (Display sales amount)
To print reports, use the following key entry sequence
MODE *1
OP X/Z
X1/Z1
X2/Z2
JOB# or KEY
DATA FOR READING
REPORT NAME
X
Z
X1
Z1
X2
Z2
*3
NOTE
GENERAL
00
---
EAN (All)
(Pick up)
(Pick up)
09
---
09
PICK UP
*4
EAN BY DEPT.
01
DEPT CODE
EAN ZERO SALES (All)
(By DEPT.)
07
---
07
DEPT CODE
DEPT./GROUP
10
---
IND. GROUP
12
GROUP No.
GROUP TOTAL
13
---
PLU BY RANGE
20
PLU CODE
*2
PLU BY DEPT.
21
DEPT CODE
PLU ZERO SALES (All)
(By DEPT.)
27
---
27
DEPT CODE
PLU PRICE CATEGORY
29
PRICE
*2
TRANSACTION
30
---
TL-ID
31
---
COMMISSION
32
---
ALL CLERK
40
---
IND. CLERK
41
---
ALL CASHIER
50
---
IND. CASHIER
51
---
HOURLY (All)
(Range)
60
---
60
TIME
*2
DAILY NET
70
---
STACKED REPORT
90
---
DEPT. SALES (Frash-read)
DEPTn
---
*5
CID (Frash-read)
[X]
---
*5
DAILY MET SALES (Frash-read)
[ST]
---
*5
NON-ACCESSED EAN
105
---
DELETE OF NON-ACCESSED EAN
105(*)
---
105(*)
PICK UP
*4
CHANGING EURO
800
---
(*) At this operation, the non-accessed EANs data are printed and
deleted.
Stop of printing reports:
The printing of all reports can be stopped by the following operation.
The printing of all reports can be stopped by the following operation.
Set the mode switch to "MGR" to cancel.
Note) When the printing is stopped, the consecutive number or Z
counter don’t return to the original value.
When Z reports, Memory is not reset.
When Z reports, Memory is not reset.
1
X1: Daily X report
X2: Periodic X report
X2: Periodic X report
Z1: Daily Z report
Z2: Periodic Z report
Z2: Periodic Z report
2
The time interval range, PLU code range can be specified by
entering the start and end numbers according to the following
procedure. When specifying a single time interval, PLU code,
the start number has only to be entered.
procedure. When specifying a single time interval, PLU code,
the start number has only to be entered.
3
When 2 is entered in the third digit of a job code, periodic reports
are printed.
Example: Daily general report; job code 100
are printed.
Example: Daily general report; job code 100
Periodic general report; job code 200
4
(Pick-up reports from EAN items)
JOB#
Range is required
Reading
Resetting
TL
XXXXXX
XXXXXX
All
Start No.
End No.
3 – 1
Click on the first or last page to see other ER-A450S (serv.man6) service manuals if exist.