DV-SL10H (serv.man8). Test mode - Sharp DVD Service Manual (repair manual). Page 3

1-7-3

TESTMODE

1. Turn the power on and remove the disc on the tray.
2. To put the DVD player into version up mode, press

[9], [8], [7], [6], and [DIRECT SKIP] buttons on the
remote control unit in that order. The tray will open
automatically.
Fig. a appears on the screen and Fig. b appears on
the VFD.

Fig. a Version Up Mode Screen

Fig. b  VFD in Version Up Mode

The DVD player can also enter the version up mode
with the tray open. In this case, Fig. a will be shown
on the screen while the tray is open.

3. Load the disc for version up.
4. The DVD player enters the F/W version up mode

automatically. Fig. c appears on the screen and
Fig. d appears on the VFD.

Fig. c Programming Mode Screen

Fig. d  VFD in Programming Mode (Example)

The appearance shown in (*2) of Fig. c is described
as follows:

Appearance

No.

State

Reading...

Sending files into the memory

Erasing...

Erasing previous version data 

Programming...

1

2

3

Writing new version data

5. After programming is finished, the tray opens auto-

matically. Fig. e appears on the screen and the
checksum in (*3) of Fig. e appears on the VFD. (Fig. f)

Fig. e Completed Program Mode Screen

Fig. f  VFD upon Finishing the Programing Mode (Example)

At this time, no buttons are available.

6. Unplug the AC cord from the AC outlet. Then plug it

again.

7. Turn the power on by pressing the power button and

the tray will close.

8. Press [1], [2], [3], [4], and [DIRECT SKIP] buttons on

the remote control unit in that order.
Fig. g appears on the screen.

Fig. g

9. Press [3] button on the remote control unit.

Fig. h appears on the screen.

Fig. H

10.To finish this mode, press [POWER] button.