DV-RW360H (serv.man4). Pages 1-7-1 to 1-14-7 - Sharp DVD Service Manual (repair manual). Page 42

1-14-2

E9B30SC

FOR CONTINUED PROTECTION AGAINST FIRE HAZARD, REPLACE ONLY WITH THE SAME TYPE FUSE.

Fixed Voltage (or Auto voltage selectable) power supply circuit is used in this unit.

If Main Fuse (F1001) is blown, first check to see that all components in the power supply circuit are not defective
before you connect the AC plug to the AC power supply.  Otherwise it may cause some components in the power
supply circuit to fail.

(1) Do not use the part number shown on the drawings for ordering.  The correct part number is shown in the parts

list, and may be slightly different or amended since the drawings were prepared.

(2) To maintain original function and reliability of repaired units, use only original replacement parts which are listed

with their part numbers in the parts list section of the service manual.

2

3

1

 5.0
(2.5)

PLAY mode
 STOP mode

5.0

The same voltage for
both PLAY & STOP modes Indicates that the voltage

is not consistent here.

< DVD Section >

2

3

1

 5.0
(2.5)
<   >

 PLAY mode
 REC mode
 DVD mode

5.0

The same voltage for
both PLAY, REC & DVD 
modes

Indicates that the voltage
is not consistent here.

< VCR Section >

Unit: Volts

1-D3

   Distinction 

Area

 Line 

Number

(1 to 3 digits)

 Examples:

  1. "1-D3" means that line number "1" goes to the line number

"1" of the area "D3".

2. "1-B1" means that line number "1" goes to the line number

"1" of the area "B1".

 

3

2

1

A

B

C

D

1-B1

1-D3

AREA D3

AREA B1

: Indicates a test point with a jumper wire across a hole in the PCB.

: Used to indicate a test point with a component lead on foil side.

: Used to indicate a test point with no test pin.

: Used to indicate a test point with a test pin.