Read Sharp HT-SB32D (serv.man3) Service Manual online
HT-SB32D
2 – 7
Move the NFC smartphone to main unit as near as possible. Tap on “Scan” key to start the “Bluetooth MAC ID”
scanning proccess. After 20 seconds, Bluetooth audio device’s address will appear in Device List (Refer Figure 10).
Device List will show all Bluetooth device’s network in air space.
Select device “HT-SB32D SHARP” on the list and the background will turn to pink colour.
The Bluetooth MAC ID address will appear in ”Address” column (Refer Figure 11).
7
Figure 9
Figure 10
Figure 11
HT-SB32D SHARP
HT-SB32D SHARP
HT-SB32D SHARP
FC:58:FA:F7:53:D1
Audio device
address will
appear here
Note: If Device List contains more than one HT-SB32D SHARP, select the device at the top of the list as the Bluetooth
signal’s strength (green bar) is the strongest.
Next, the writing process can begin.
Touch the NFC smartphone onto the tag (within 2 - 3 seconds) until the screen pop up message “Write tag successful”
Touch the NFC smartphone onto the tag (within 2 - 3 seconds) until the screen pop up message “Write tag successful”
or “Tag was lock, only BT address is rewritten” appears. Information will be written into the NFC tag. Tap on ‘OK’ to exit
pop up message.
If “Fail to write tag” message pops up when writing is in progress, tap on ‘Retry ’ and try again until successful.
Note: The location of NFC antenna on a smartphone varies between brands. Please refer to smartphone’s
Note: The location of NFC antenna on a smartphone varies between brands. Please refer to smartphone’s
User Manual for more information.
8
NFC tag is ready to be sent to customer.
9
Figure 12
Figure 13
Figure 14
Figure 15
HT-SB32D SHARP
HT-SB32D SHARP
HT-SB32D SHARP
HT-SB32D SHARP
HT-SB32D SHARP
Click on the first or last page to see other HT-SB32D (serv.man3) service manuals if exist.