Read Sharp HT-SB250 User Guide / Operation Manual online
10
HT-SB250(BK)
2010 December 29
HT-SB250_A6_EN_UK.fm
HT-SB250(W)
Prep
arat
ion fo
r
Us
e
System preparation (continued)
Caution:
z
Be very careful to prevent the unit [1.90 kg] from falling when
mounting on the wall.
mounting on the wall.
z
Before mounting, check the wall strength. (Do not put on the
veneer plaster or whitewashed wall. The unit may fall.) If
unsure, consult a qualified service technician.
veneer plaster or whitewashed wall. The unit may fall.) If
unsure, consult a qualified service technician.
z
Mounting screws are not supplied. Use appropriate ones.
z
Check all wall mount angle screws for looseness.
z
Select a good location. If not, accidents may occur or the unit
may get damaged.
may get damaged.
z
SHARP is not responsible for accidents resulting from
improper installation.
improper installation.
Driving screws
SHARP designed the units so you may hang them on the wall.
Use proper screws (not supplied). See below for size and type.
Wall mount angle fixed to the wall
(Horizontal position)
(Continued to the next page)
To mount the unit on the wall
3.2 mm
9 mm
Min. 22 mm
5 mm
1
Fix the pattern paper to the wall in horizontal position
as below.
2
Make a hole on the wall following the screw point
marks on the pattern paper by using a drill.
3
Fix a wall mount plug into the hole using a hammer,
until it is flush with the wall surface.
until it is flush with the wall surface.
29 mm
29 mm
44 mm
44 mm
509 mm
Pattern paper
Wall surface
Wall surface
8-9 mm
32 mm
Wall surface
8-9 mm
32 mm
Click on the first or last page to see other HT-SB250 service manuals if exist.