Read Sharp R-874 (serv.man10) User Guide / Operation Manual online
Instant Cook, Express Cook and Meal In One modes. To prevent burns,
use thick oven gloves when removing food or the turntable from the oven.
2 Oven lamp
3 Control panel
4b Door opening handle (R-884M)
6 Oven cavity
7 Turntable motor shaft
8 Grill heating element (bottom grill)
11 Outer cabinet
12 Power cord
Check to make sure the following
accessories are provided:
13 Turntable 14 Turntable motor shaft
Place the turntable on to the turntable motor shaft so that it locates firmly.
To avoid turntable damage, ensure dishes and containers are lifted clear
of the turntable rim when removing them from the oven.
15 Low rack and 16 High rack (For use of the racks, refer to the grilling,
convection and dual cooking sections on pages 11 - 15).
• Never touch the bottom grill when it is hot.
• Always operate the oven with the turntable and support fitted
turntable may rattle, may not rotate properly and damage the oven.
affect cooking performance.
11. WEIGHT indicators
12. TIME keys
14. EXPRESS COOK keys
15. EXPRESS DEFROST keys
16. MEAL IN ONE keys
17. CONV. (°C) key
18. DUAL CONV./GRILL key
19. LESS/MORE keys
20. INFO key
21. START/AUTO MINUTE key
22. STOP/CLEAR key
23. KITCHEN TIMER/CLOCK SET key
24. WEIGHT CONVERSION key
25. WEIGHT keys
26. MICRO. POWER key
27. GRILL key
12. TIME keys
100% for 1 minute or increase time during cooking
in multiples of 1 minute.
standing time. Press twice to set the clock.
pieces. When minimum (or maximum) weight/
number is reached, the display will not change, even
if you continue to press the DOWN (or UP) key.
Inspect the Oven:
If any damage is apparent, do not
operate the oven in any way. Contact
your dealer or SHARP approved
service facility. (see p. 66)
plastic film from the inside of the oven window as
this protects it from dirt. The waveguide cover
prevents food and grease from entering the
waveguide area where it could cause damage.
DO NOT REMOVE.
item likely to be cooked in the oven.
necessary above the
top sur face of the
oven is 19cm.
oven is 85cm or more above the floor.
or above a conventional oven) or near
combustible materials (for example, curtains). Do
not block or obstruct air vent openings. Do not
place objects on top of the oven.
below) and that it does not run under the oven or
over any hot or sharp surfaces.
The R-884M microwave oven is not designed to be
built-in to a kitchen unit.
R-84STM which enables the microwave oven to be
integrated within a kitchen unit.
The microwave ovens are not designed to be built
above or near a conventional oven.
SHARP recommend the use of the build in kit,
EBR-4700 (R-874M) or EBR-47ST (R-84STM),
available from your SHARP dealer. Only the use of
this frame will guarantee the quality and safety of
the oven. When building, follow installation
special cord. The exchange must be made by an
authorised SHARP service agent.
damage the power supply cord and the
connections inside the plug.
your home, remove the plug and fit an
appropriate type, observing the wiring code given
in `To replace the mains plug’ on page 65.
ensure the plug is removed properly and not cut off.
When replacing the plug please ensure that you use
a BSI or ASTA approved plug to BS1363, this should
be fitted with a brown coloured 13 amp fuse
approved by BSI or ASTA to BS1362. If you have
any doubt about electrical connection seek the help
of a qualified electrician.
given in `To replace the mains plug’ on page 65.