GX-M10H (serv.man2) - Sharp Audio User Guide / Operation Manual. Page 5

After checking all the connections have been made correctly, plug 
the AC power lead of this unit into the wall socket.

  Remove all batteries when using AC power.
  Unplug the AC power lead from the wall socket if the unit will not 

be in use for a prolonged period of time.

  During battery/DC operation, the unit will be set to Demo mode 

off with display and subwoofer light in MODE 2 to reduce the 
battery power consumption.

  When using battery/DC power, the remote control cannot be 

used to turn on the unit.

  Unplug the AC power lead from the unit before using the DC 

power. Otherwise the unit will not work.

  Use only a car adaptor with DC 12V output voltage.
  Insert the plugs fi rmly.
  When the unit is not in use for an extended period, remove the 

car adaptor from the car supply socket.

12V

24V

Black

Red

Attention: connection of DC lead and 
battery terminals.

 :  Connect the red battery clip to (+) on 

the battery terminal.

 :  Connect the black battery clip to (–) 

on the battery terminal.

DC power can only be used for a 12V 
battery.
Do not use any battery besides a 12V.

  Connection of the AC or DC power lead to the unit disconnects 

the batteries.

  When inserting or removing the batteries 5 and 0, push them 

towards the (-) battery terminals.

  Installing the batteries incorrectly may cause the unit to malfunction.
  Batteries are not included.

  Insert the batteries according to the direction indicated on the 

rear panel.

  Remove the batteries if they are weak or if the unit will not be 

used for long periods of time. This will prevent potential damage 
due to battery leakage.

  Replace all old batteries with new ones at the same time. 
  Do not mix old and new batteries.

  When batteries are low, battery indicator “

” will blink to show  

that the batteries need to be replaced. sound may become 
distorted and unit may automatically turn off or mute during high 
volume level. Reduce the volume level or replace the batteries.

  When replacing the batteries, place the unit on a cushion or soft 

cloth to avoid damage.

  Do not use rechargeable battery (nickel-cadmium battery, etc.).
  Immediately remove the discharged batteries. If the chemical 

leak into the unit, clean it.

  Batteries (battery pack or batteries installed) shall not be 

exposed to excessive heat such as sunshine, fi re or the like.

  The fi rst time the unit is plugged in with AC power, the unit will 

enter the demonstration mode. You will see words scroll and the 
subwoofer light up will operate in the fl ashing mode.

  To cancel the demonstration mode, press the DEMO/DIMMER 

button (remote control) during power stand-by mode. The unit 
will enter the low power consumption mode. The subwoofer light 
will be off. 

  To return to the demonstration mode, press the DEMO/DIMMER 

button again.

  If iPod or iPhone is docked, the unit will begin charging. “iPod 

CHARGING” will be displayed.

To DC IN 12 V 

socket

Car adaptor (not supplied)
Socket: DC 12 V 4.5 A  

To AC INPUT 
socket

Wall socket
AC 110 - 240 V ~ 
50/60 Hz

GX-M10H_OM_UK_OK_JU.indd   Sek1:4

GX-M10H_OM_UK_OK_JU.indd   Sek1:4

2012-08-14   23:23:44

2012-08-14   23:23:44