DK-UH2BK - Sharp Audio User Guide / Operation Manual. Page 11

DK-UH2

DK-UH2(BK)

In this example, the clock is set for the 24-hour (0:00) display.

To confirm the time display:
[When the unit is in the power stand-by mode]
Press the CLOCK button. The time display will appear for about 10
seconds.

[When the power is on]
Press DISPLAY button on the remote control to toggle between the
function information and clock display.
Press the CLOCK button. The time display will appear for about 10
seconds.

The clock will continue counting for 8 hours should there be a
power failure or the AC power lead becomes disconnected.
The “CLOCK ADJ” will appear or time will flash to confirm the time
display when the AC power supply is restored after a power failure
or unplugging the unit. If incorrect, readjust the clock as follows.

To readjust the clock:
Perform “Setting the clock” from step 1 to step 4.

The 24-hour display will appear.

 

(0:00 - 23:59)

The 12-hour display will appear.

 

(12:00 AM- 11:59 PM)

Press the 

 or 

 button once to advance the time by 1 hour.

Hold it down to advance continuously.

4

4

7

6

Press the 

 or 

 button once to advance the time by

1 minute. Hold it down to change the time in 5-minutes interval.

1

Clear all the programmed contents. [Refer to “Factory reset,
clearing all memory” on page 21 for details.]

2

Perform “Setting the clock” from step 1.

1

Press  the  

  button  at  remote  control  to advance  the  time

1  hour. 

  indicator  will appear on display.

2

Press the 

 button again to turn the clock back 1 hour.

“0:00”  

“12:00”