CP-SW1000H - Sharp Audio User Guide / Operation Manual. Page 8

9

CP-SW1000H

Main unit operation:
Turn volume knob clockwise to increase the volume and anti-
clockwise to decrease the volume.
Remote control operation:
Press the VOL + button to increase the volume and the VOL – button
to decrease the volume.
Note:
Do not turn the volume knob manually in reverse direction when
operating it by remote control.

Adjust the high frequency cut-off point. Frequencies higher than the
set frequency are removed.
To emphasise the bass, turn this control towards 80 Hz and increase
the volume.

Notes:
Observe the following to avoid malfunction and sound distortion.

Do not set the volume too high on the audio system. The
subwoofer may be damaged.
Before you switch on/off the subwoofer, minimise the volume on
the audio system.

If no signal is detected for 20 minutes during power on, the
subwoofer will automatically go to stand-by mode.

You can operate SHARP TV with this system’s remote control.

Other operable button
Press the Input Select button to switch the input source. (TV)
Note:
Some models of SHARP TV may not be operable. In this case, use
the remote control supplied with each product.

Point the remote control at the TV.

Press the CH UP   or CH DOWN   button to set the
channel.
Pressing the CH UP 

 or CH DOWN 

  button enables TV

channel switching.

TV operation buttons