Read Sharp CP-SW1000H User Guide / Operation Manual online
E-6
ENGLISH
9
CP-SW1000H
Preparation for Use
AC power connection
After checking all the connections have been made correctly,
connect the AC power lead to the AC power input socket, then to the
wall socket.
connect the AC power lead to the AC power input socket, then to the
wall socket.
Notes:
Never use a power lead other than the one supplied. Otherwise,
a malfunction or an accident may occur.
a malfunction or an accident may occur.
Unplug the AC power lead from the wall socket if the unit will not
be in use for a prolonged period of time.
be in use for a prolonged period of time.
Remote control
Battery installation
Precautions for battery use:
Remove the battery if the unit will not be used for long periods of
time. This will prevent potential damage due to battery leakage.
time. This will prevent potential damage due to battery leakage.
Caution:
Do not use rechargeable battery (nickel-cadmium battery, etc.).
Replace only with the same or equivalent type.
Installing the battery incorrectly may cause the unit to malfunction.
Danger of explosion if battery is incorrectly replaced.
Batteries (battery pack or batteries installed) shall not be exposed
to excessive heat such as sunshine, fire or the like.
Replace only with the same or equivalent type.
Installing the battery incorrectly may cause the unit to malfunction.
Danger of explosion if battery is incorrectly replaced.
Batteries (battery pack or batteries installed) shall not be exposed
to excessive heat such as sunshine, fire or the like.
Wall socket
(AC 220 - 240 V ~ 50 Hz (Europe))
(AC 220 - 240 V ~ 50/60 Hz (others))
(AC 220 - 240 V ~ 50 Hz (Europe))
(AC 220 - 240 V ~ 50/60 Hz (others))
1
Whilst pushing the locking tab towards the centre of the
remote control, slide out the battery holder.
remote control, slide out the battery holder.
2
Remove the old battery from the battery holder, insert the
new battery and then slide the battery holder back into the
remote control.
new battery and then slide the battery holder back into the
remote control.
Back of remote control
Locking tab
Battery holder
Polarity (+) symbol
Battery type
Locking tab
Positive (+) side up
Click on the first or last page to see other CP-SW1000H service manuals if exist.