CD-RW5000 - Sharp Audio User Guide / Operation Manual. Page 51

Web-site: www.sharp.co.uk/support    Help Line: 0990 274277 (office hours)

Many potential “problems” can be resolved by the owner without calling a service tech-
nician. If something is wrong with this product, check the following before calling your
authorised SHARP dealer or service centre.

■

●

Radio makes unusual noise con-
secutively.

■

●

The remote control does not op-
erate.

●

The stereo system is placed near the TV
or computer.

●

FM/AM loop aerial is not placed prop-
erly. Move the AC power lead away from
the aerial if located near.

●

Is the AC power lead of the stereo sys-
tem plugged in?

●

The battery polarity is not respected.

●

The batteries are dead.

●

Incorrect distance or angle.

●

Does the remote control sensor receive
strong light?

■

●

The clock is not on time.

●

When a button is pressed, the unit
does not respond.

●

No sound is heard.

●

Did a power failure occur?

●

Reset the clock. (Refer to page 17.)

●

Set this unit to the power stand-by mode
and then turn it  back on.

●

If the unit still malfunctions, reset it.
(Refer to page 53.)

●

Is the volume level set to “0”?

●

Are the headphones connected?

●

Are the speaker wires disconnected?

■

●

Cannot record.

●

Cannot record tracks with proper
sound quality.

●

Cannot erase completely.

●

Sound skipping.

●

Cannot hear treble.

●

Sound fluctuation.

●

Cannot remove the tape.

●

Is the erase-protection tab removed?

●

Is it a normal tape?

●

(You cannot record on a metal or CrO

2

tape.)

●

Is there any slack? Is the tape stretched?

●

Are the capstan, pinch roller, or heads
dirty?

●

If a power failure occurs during playback,
the heads remain engaged with the tape.
Do not open the compartment forcibly.
Wait until electricity resumes.

■

●

Playback does not start.

●

Playback stops in the middle or is
not performed properly.

●

Playback sounds are skipped, or
stopped in the middle of a track.

●

The disc is loaded up-side down.

●

The disc does not satisfy the standards.

●

The disc is distorted or scratched.

●

Is the unit located near excessive vibra-
tions?

●

The disc is very dirty.

●

Has condensation formed inside the
unit? (Refer to page 52.)

**RW5000H_P51_55(References)

00.7.29, 8:19 AM

51