Read Panasonic TX-47PT10F / TX-47PT10P Service Manual online
HOW TO MOVE THE CHASSIS INTO SERVICE POSITION
1.
Remove the PCB clamp (A) located between chassis and DG PCB as shown in Fig1.
2.
Remove the gnd connections to A51 & A52 , also undo all wire dressing clips as shown in Fig2.
3.
Remove shielding connector and the connection to power terminal on P-PCB (P2) as shown in Fig3.
4.
Hold and lift the rear of the chassis and gently pull the chassis towards you , as shown in Fig4.
5.
Remove all connectors connecting away from main chassis and rotate through 90 degrees , vertically
as shown in Fig5.
as shown in Fig5.
6.
After servicing replace the PCB clamper (A) and and ensure all wiring is returned to its original position before
returning the receiver to the customer.
returning the receiver to the customer.
WIRE
DRESSING
DRESSING
(A)
GND CONNECTORS
A51 & A52
A51 & A52
SHIELDING
EARTH
EARTH
CONNECTION
TO P2
TO P2
Fig1.
Fig2.
Fig3.
Fig4.
Fig5.
4
Click on the first or last page to see other TX-47PT10F / TX-47PT10P service manuals if exist.