Read Panasonic TC-29V10N Service Manual online
- 11 -
0
0
180
3.0V
2.45
0.05V
Adjustment
1. Press the remote control button " " with S-BRT to make the
screen one horizontal line, and then adjust with the [VOL +/-]
buttons of the remote control transmitter so that the waveform
of TLP2 on theprinted circuit board [L] for the picture tube
becomes DC 2.45
0.05V in regard to earth, as shown in the
figure on the right, when measured with the oscilloscope
probe. (For return to the adjustment item, press the button " "
again.)
2. Press the remote control button with G-CUT to make the
screen one horizontal line, and then adjust with the [VOL +/-]
buttons of the temote control transmitter so that the waveform
of TLP7 on the printed circuit board [L] for the picture tube
becomes DC 180
3.0V in regard to earth, as shownin the
figure on the right, when measured with the oscilloscope
probe.
3. Turn the screen volume gradually to the right, and fix it when only the green color shines lightly.
4. Select the R and B-CUT items for the colors red and blue, which are not lit, and adjust with the [VOLV +/-]
buttons of the remote control transmitter so that the three colors shine lightly at the same level and white color is
obtained.
5. Turn the screen volume to the left, so that the three colored horizontal lines disappear.
6. Press the remote control button to return to the normal screen.
7. Select the items R, B-DRV and adjust with the [VOL +/-] buttons of the remote control transmitter so that a
normal black-and-white screen is cbtained.
•
Use the image menu to change the [Black level], and confirm that a normal black-and-white screen is
obtained.
•
Also confirm the screen brightness for all channels.
Adjust with S-BRT when the screen is too bright or too dark.
When a normal black-and-white screen can not be obtained, repeat the adjustments 3 to 7.
White balance adjustment
Prepare
•
Oscilloscope
•
WB adjustment
•
Image menu [Dynamic standard]
R-CUT
[000]
(Min. value)
Color darkness
[0]
(center)
B-CUT
[000]
(Min. value)
Hue
[0]
(center)
R-DRV
[00]
(Min. value)
Black level
[0]
(center)
B-DRV
[00]
(Min. value)
Picture
[+30]
(Max.)
G-CUT
[7F]
(Center value)
Color temperature
[high]
•
Power consumption
[standard]
Amplitude compensation adjustment
Prepare
DC voltage meter or digital tester
(Do not use standard tester)
Adjustment
1. In the menu [Image OFF setting], set image to [OFF] and set the raster to dark black.
2. Connect the
side of a DC voltmeter or a digital tester to [D2]
: (TRX3), and connect the
side to earth.
3. Turn the knob of R712 (high voltage adjustment) and adjust to 4.0V 0.1V.
4. Select image [ON] at the menu. Confirm that the image is free of abnormalities.
+
-
!"
Click on the first or last page to see other TC-29V10N service manuals if exist.