Read Panasonic TC-29V10N Service Manual online
Type29 (73 cm)
Mass and dimensions shown are approximate.
Stand-by condition 0.4W
100 position (Auto Search)
at zero beam current
supply before servicing a hot chassis.
cially the lead dress in the high voltage circuits.
If a short circuit is found, replace all parts which have
been overheated or damaged by the short circuit.
such as insulation barriers, insulation papers, shields,
and isolation R-C combinations, are properly installed.
time, unplug the power cord from the AC outlet.
the rear cover involves the danger of a shock hazard
from the receiver power supply. Servicing should not be
attempted by anyone who is not thoroughly familiar with
the precautions necessary when working on high volt-
age equipment. Always discharge the anode of the pic-
ture tube to the receiver chassis before handling the
checks to prevent the customer from being exposed to
two prongs on the plug.
between the jumpered AC plug and each exposed
metallic cabinet part on the receiver, such as screw
heads, aerials, connectors, control shafts, etc. When the
exposed metallic part has a return path to the chassis,
the reading should be between 4 M
the chassis, the reading must be
an isolation transformer for this check.
sure the potential across the resistor.
voltage at each point.
the above measurements.
there is a possibility of a shock hazard, and the receiver
should be repaired and rechecked before it is returned to
High Voltage section and the picture tube.
that jig is capable of handling
brated high voltage meter.
to prevent the possibility of premature component fail-
use the specified picture tube.