Read Panasonic TC-21P50R Service Manual online
- 12 -
Item / Preparation
Adjustment Procedure
NTSC SUB-TINT
1. Connect oscilloscope probe to TPA40 (R OUT).
2. Input Rainbow-Pattern (3.58MHz NTSC)
to VIDEO-IN terminal, and set AV mode by
TV/AV select button.
TV/AV select button.
3. Connect short-jumper to TPA57 and
TPA50.
4. Connect short-jumper to FBT pin3 and
TPA32.
5. Picture menu : DYNAMIC NORMAL.
AI : OFF
Channel colour SET....STD.
Channel colour SET....STD.
1. Adjust Sub-NTSC-TINT, so that levels of NO.2, NO.3, NO4 (Fig.1)
become Fig,2.
2. Confirm the waveform is 1.3Vp-p.
SECAM BLACK LEVEL
1. Receive the SECAM colour bar pattern.
Input RF signal level : 75dB
(75
(75
W
opened).
2. Picture menu : DYNAMIC NORMAL.
AI : OFF
3. Channel colour SET....STD.
4. Enter factory mode, then go to CHK2.
5. Connect short jumper from FBT pin 3 to
4. Enter factory mode, then go to CHK2.
5. Connect short jumper from FBT pin 3 to
TPA32.
1. Press digit '4' until R-Y appears.
2. Connect oscilloscope prebe to TPA52 (R-Y out).
3. Connect oscilloscope prebe ground to TPA54 (IC601 pin 32. gnd).
4. Adjust R-Y so that point A and point B center line are flat. See Fig.1.
2. Connect oscilloscope prebe to TPA52 (R-Y out).
3. Connect oscilloscope prebe ground to TPA54 (IC601 pin 32. gnd).
4. Adjust R-Y so that point A and point B center line are flat. See Fig.1.
5. Connect oscilloscope prebe to TPA53 (B-Y out). Press digit '4' until B-Y
appears.
6. Adjust B-Y so that point C and D center line are flat. See Fig.2.
1
2
3
4
5
6
Fig.1
Fig.2
7
8
9
10
A
B
2
3
4
A : B = 2 : 3
A
B
C
Fig.2
Fig.1
D
Click on the first or last page to see other TC-21P50R service manuals if exist.