Read Panasonic CT-34WX50 Service Manual online
- 10 -
P3
P2
P1
D3
8pin Cable
8pin Cable
D2
D1
3pin Cable
Inspection of the P-Board
As the P-Board can not be inspected from the pattern
side, refer to the pattern side/parts side of the circuit dia-
gram (Page 66, 67), and perform the inspection by bring-
ing the tester into contact with the jumper wires and
parts.
side, refer to the pattern side/parts side of the circuit dia-
gram (Page 66, 67), and perform the inspection by bring-
ing the tester into contact with the jumper wires and
parts.
Parts exchange for the
P-Board
(1) When parts are to be exchanged, first remove the screws
(3 screws: to Refer to Fig. 4) fixing the print holder.
(2) Next, remove the screws (3 screws: to :Refer to
Fig.4)
(3) Remove the P-Board from the D-Board (3 connectors: P1
to P3: Refer to Fig. 4), and then exchange the parts.
*
Pay attention to the earthing of HOT and COLD parts and
perform inspection.
perform inspection.
(1) Remove the rear panel fixing screw (6 screws: to )
and the fixing tabs (2 place). (Refer to Fig. 5)
(2) Tilt the H-Module to the front and pull it out, and then
exchange the H-Module.
Fig.4
Inspection of the P-Board
Fig.5
H-Module exchange
1
6
2
5
4
3
Front
Top View
Rear View
P-Board
Print Holder
2
1
3
5
6
4
Tab
H-Module
Rear Bracket
1
3
4
6
!
1
6
"#$%&$'($)($%($($%$
(($$$
!
*"+,-./''
Click on the first or last page to see other CT-34WX50 service manuals if exist.