Read Panasonic KX-NT511ARUW / KX-NT511ARUB Service Manual online
14
KX-NT511ARUW/KX-NT511ARUB
7 Test Mode
7.1.
Loopback Test Mode
This is for VoIP Communication Test Connection Chart.
7.1.1.
Preparation
Preparation device
• Unit for Test phone
• AC adaptor
• AC adaptor
Set up unit in test mode by key control
1. Connect power plug (AC adaptor).
2. Push [1][ ][CONF] keys within 5 seconds after power on and turn off the Red LED.
3. Keep it until "Now Loading" is displayed on LCD.
2. Push [1][ ][CONF] keys within 5 seconds after power on and turn off the Red LED.
3. Keep it until "Now Loading" is displayed on LCD.
Now Loading
*If "IPL start..."is displayed before "Now Loading" on LCD,it fails in the setting for Test mode
Try agin from Step.1
Try agin from Step.1
4. Release keys.
5. After 10 seconds,"HOOK Test" is displayed on LCD.
6. Press "SP-phone" key 6 times slowly.
5. After 10 seconds,"HOOK Test" is displayed on LCD.
6. Press "SP-phone" key 6 times slowly.
"ACOUSTIC TEST" is displayed on LCD.
7.1.2.
Communication Test
It is set to Loopback Test mode to connect "Send signal" with "Receive signal" by inputting two number.
Input number is 6 and 7 and the mode is as follows
(I) : Input 6.SP-phoneMIC 7.HandsetMIC
(O): Output 6.SP-phoneSP 7.HandsetSP
(I) : Input 6.SP-phoneMIC 7.HandsetMIC
(O): Output 6.SP-phoneSP 7.HandsetSP
For example
1. Handset MIC
Handset SP
7 7
I:HsMic / O:HsSp
No sound
2. Handset MIC
SP-phone SP
7 6
I:HsMic / O:Sp
OK
This result shows there is a problem in the signal line of Handset SP.
7.1.3.
Quit Test Mode for communication test
Just power off.
AC Adaptor
(AC Adaptor : PNLV226**)
(AC Adaptor : PNLV226**)
Click on the first or last page to see other KX-NT511ARUW / KX-NT511ARUB service manuals if exist.