Read Panasonic PT-RZ120 (serv.man2) Service Manual online
INF-14
SECTION 1 SERVICE INFORMATION
< RZ120 >
15. BLENDING MODE
• When edge blending is used, set when coloring is conspicuous in the overlapped image area.
In case of multi-display screen, it is necessary to unify "BLENDING MODE" of each projector.
- MODE1 : Normal mode. (Default)
- MODE2 : Set when coloring is conspicuous in the overlapped image area.
* If you change the MODE setting after installation adjustment, readjustment is required because various user adjustment
values are reset.
* The coloring of the overlapped image area may occur when the setting position deviation or setting is incorrect. Check the
installation condition first.
16. DIGITAL LINK OPTION
• Setup when failing the DIGITAL LINK firmware updating. (Normally not used)
- 0 : Normal (Default)
- 1 : Firmware writing mode by the special tool.
17. DIGITAL LINK (ETHERNET CONTROL)
• Under the dual LAN system configuration, setup to avoid the loop interference due to commands controlled from both
terminals.
- ENABLE : Enables the network command control from DIGITAL LINK terminal. (Default)
- DISABLE : Disable the network command control from DIGITAL LINK terminal.
* It takes a time to effect the setting after switching.
18. HDMI HOT PLUG CONTROL
• At the turning on the projector, setup when the abnormal HDMI signal (no information frame, etc.) is output from source
equipment, it controls the Hot Plug and outputs the signal again.
- DISABLE : Hot Plug is "High" during connecting to the source equipment.*1 (Default)
- POWER ON : Hot Plug is switched from "Low" to "High" once when starting up the main power supply.*1, *2
*1 : When changing the setting of "EDID Selection" or "EDID Mode" on the HDMI IN menu, the Hop Plug becomes
"Low".
*2 : The source equipment may output the signal again to the connected equipment (monitors, projectors).
Click on the first or last page to see other PT-RZ120 (serv.man2) service manuals if exist.