PT-RQ13K (serv.man2) - Panasonic Projector Service Manual (repair manual). Page 32

INF-22

[Note] 

  • Air filter replacement is recommended after cleaning the unit two times.

    The dust-proof properties may be reduced after each cleaning.

  • Do not disassemble the air filter unit.

  •  When using the "Smoke cut filter", please enter the service password and change the filter type settings.

    Also, when you have finished using the "Smoke cut filter", please return the filter setting.

    For more information, please refer to the operating instructions of the smoke cut filter.

Model Number

Service Password

Filter type

Self-diagnosis display

Note

ET-SFR330

1111

SPECIAL

U75

1. The lithium battery is used for the internal clock in the A-P.C.Board. So when it consumed it must be replaced.

 

  Lithium battery : CR2032

* Use only specified lithium battery.

* Used battery must be scrapped according to the instruction.

2. After replacing the lithium battery, surely set the "Date and Time" on the sub-menu in the main menu "projector set up".

1. This projector is equipped with two SLOT NX-specification slots.
  “SLOT NX” is a name of the slot unique to Panasonic supporting the signal input for the 4K image.
2. There are four SDI input terminals and one DIGITAL LINK input terminal equipped on this projector as the standard
   video input terminals.
   The input for HDMI, DVI-D, and SDI can be added by installing the optional Interface Board in the slot.

The basic service policy is shown below.

Repair contents

Applied parts

Block replacement 

P.C.Board replacement

- [PF] -P.C.Board (Fuse on the primary circuit can be replaced individually)
- [PB]-P.C.Board
- [D]-P.C.Board (Fuse on the primary circuit can be replaced individually)
- [DR]-P.C.Board
- Wob unit
- LD unit
- Rod Assy
- Mechanical shutter

Refurbish at the factory

- DMD block

Replaced by discrete components

- Other electrical parts and mechanism parts

1. Hexalobe (TORX type) driver [2.72 mm]

  • VESSEL T10H or comparable product

  • Part No. : TZSH07035

2. Hexalobe (TORX type) driver [3.94 mm]

  • VESSEL T20H or comparable product

  • Part No. : TZSH07042

3. Hex wrench/Hex ball-point driver 

  •[2.5mm] : Use for the lighting area adjustment.

  •[2.0mm/1.5mm] : Use for the convergence adjustment.

4. Laser safety glass

  • Please wear glasses for safety when checking with the cover removed.

  • Type : Full absorption, Adaptation laser : Ar, Wavelength : 448 - 462nm

  • Part No. : TZSH07038 (or comparable product)