PT-RQ13K (serv.man2) - Panasonic Projector Service Manual (repair manual). Page 26

INF-16

  •  Set this when you want to turn off the indicator LED.

    [INDICATOR MODE]

      - NORMAL : The indicator maintains lighting (Default)

      - OFF : The indicator will be forcibly turned off.

      - TIMEOUT : The indicator turns off when no operation is taken for a certain time.

    [NO ACTIVITY TIME]

      Setup the time to turn off when INDICATOR MODE setting is TIMEOUT.

      You can set the time up to 15 minutes in 1 minute. (default setting is 15 MIN.)

      *If INDICATOR MODE setting is NORMAL or OFF, this will be grayed out.

    [INTERLOCKED 7SEG DISPLAY]

      Set this when you want to turn off the Self-diagnosis display (7SEG) on the control panel.

      - ON : Self-diagnosis indication will be linked with setting of INDICATOR MODE. (Default)

      - OFF : Self-diagnosis indication maintains lighting not linking with the setting of INDICATOR MODE.
      *If INDICATOR MODE setting is NORMAL, this will be grayed out.

  • The following 3 items are added to the [USER] setting in sub menu [DYNAMIC CONTRAST].

    [LIGHTS OUT FADE-IN] *

      - Sets up the time period of fade-in operation at the light out timer operaton. (Off, 0.5 to 10 sec.)

    [LIGHTS OUT FADE-OUT] *

      - Sets up the time periods of fade-out operation at the light out timer operaton.(Off, 0.5 to 10 sec.)

      * : If LIGHTS OUT TIME setting is DISABLE, those will be grayed out.

    [AI WINDOW]

      - Sets up the APL detective area. (AUTO/MANUAL, further settings are available in MANUAL mode)

  • [DVI EQUALIZER] is added to a sub menu. 

    (When the DVI-D Interface Board is installed in the slot.)

     When noise contamination to DVI input caused by long cable

    or external device, set this item so that the noise decreases.

     (AUTO/0 - 15)

  (1) The following items are added to [SDI IN] sub menu.

      [XYZ TO RGB SETTING]

    - FACTORY SETTING : Uses the value of FACTORY 

      Yxy conversion factor to the original data of XYZ → RGB.

    - MEASURED : Uses the value of MEASURED

       Yxy conversion factor to the original data of XYZ → RGB.

    - REC709 : Uses the value of REC709 Yxy conversion

       factor to the original data of XYZ → RGB.

    - DCI P3 : Uses the value of DCI P3 Yxy conversion

       factor to the original data of XYZ → RGB.

      [XYZ TEST PATTERN]

    - WHITE : 10% ~ 100%

    - DARK GRAY : 1 ~ 10

    - COLOR : Red/Green/Blue/Cyan/Magenta/Yellow of 1 ~ 2