PT-RQ13K (serv.man2) - Panasonic Projector Service Manual (repair manual). Page 25

Read Panasonic PT-RQ13K (serv.man2) Service Manual online

INF-15
SECTION 1 SERVICE INFORMATION
< RQ13K >
4. POWER OFF MESSAGE
  • Setting of the shutter function with standby operation
- SHUTTER KEEP:  When pushing the standby key while the shutter mode is on, the projector keeps the shutter mode on 
and sets into standby mode.
- SHUTTER OPEN:  When pushing the standby key while the shutter mode is on, the projector opens the shutter and displays 
the "Power OFF confirmation message". (Default setting)
5. ERROR OSD
  •   Enables to display the error information of the LIGHT indicators on the screen (It is useful when using the projector with 
rear projection mode)
    - ON :  "LIGHT1\LIGHT2 ERROR" is displayed on the screen if the lighting error occurs. (It will disappear when any of the 
control buttons is pressed.)
    - OFF : No message is displayed on the screen if the lighting error occurs. (Default setting)
6. ELECTRIC CONVERGENCE
  • Aligns the convergence electrically. refer to chapter SECTION 3 (Adjustments)
7. MECHANICAL CONVERGENCE
  • Aligns the convergence mechanically. refer to chapter SECTION 3 (Adjustments)
8. MODEL
  This setting is necessary when the A-P.C. Board is replaced with new one.
    • If you can copy EEPROM data from old A-P.C. Board, this setting is unnecessary.
    • This model setting is effective after power restart.
9. CLOG SENSOR CALIBRATION
  •  This is to calibrate the clog sensor circuit. This calibration is necessary when the [A]-P.C Board, EEPROM (IC3711/IC3712) 
or [M2]- P.C. Board is replaced. 
  • Refer to the chapter SECTION 3 (Adjustments) for the procedure.
10. SMOKE FILTER DISPLAY
  •  Setting of the warning display (self-diagnosis display "U75") at the time of smoked cut-off filter use.
    - ON : Warning is displayed. (Default)
    - OFF : Warning is not displayed.
11. LIGHT SELECT
  •  Select the LD to turn on. Press the [ENTER] key to switch.
    – ALL : Both of LD1/LD2 turn on (Default)
    – LD1 : LD1 turns on 
    – LD2 : LD2 turns on
  • The selection will be reset to "ALL" after turning off the projector.
(30) 
- Fans control check (1: normal / 0: abnormal)
(31) 
- Luminance sensor check (detected value)
(32) 
- Atmospheric pressure sensor check (hpa/Celsius)
(33) 
- Angle sensor check (Horizontal angle / Vertical angle)
(34) 
- Shutter control check (Opening and shutting times [Failure times])
2.
)$1
5DGLDWRU
5DGLDWRU
5DGLDWRU
5DGLDWRU
5DGLDWRU
5DGLDWRU
([KDXVW
([KDXVW
,QWDNH
,QWDNH
&RORUSULVP
&RORUSULVP
%'0'
'0'H[KDXVW
'0'H[KDXVW
6LJQDOEORFN
6LJQDOEORFN
/'GULYHU
3XPS
3XPS
Page of 127
Display

Click on the first or last page to see other PT-RQ13K (serv.man2) service manuals if exist.