Read Panasonic PT-MZ16K / PT-MZ13K / PT-MZ10K (serv.man2) Service Manual online
DIS-32
SECTION 2 DISASSEMBLY PROCEDURE
<MZ16K/MZ13K/MZ10K>
3.2.1. Polarizer (Out) removal
1. Remove each 1 hex screw-B on the polarizer holder with a ball pointed driver (2.0) and
take the Polarizer (Out) upward off carefully.
B
B
B
B-Polarizer (Out)
(Inorganic type)
G-Polarizer (Out)
(Inorganic type)
R-Polarizer (Out)
(Inorganic type)
Al evaporated side
(Light incoming side)
Al evaporated side
(Light incoming side)
Al evaporated side
(light incoming side)
B
Torque : 2.5 ~ 3.5 kgf.cm
Pay attention not to scratch on the sur-
face of the Polarizer (Out) when remov-
ing the polarizer.
LCD panels used for this model cannot be replaced separately. Do not disassemble the Optical block. These LCD
panels are installed with precision at the factory. When replacing the LCD panel, should be replaced whole of the
LCD panels and prism assy at once. When replacing optical block, take the optical and electrical adjustments fol-
lowing to the chapter "Adjustment".
Important notice on the Optical block replacement
Click on the first or last page to see other PT-MZ16K / PT-MZ13K / PT-MZ10K (serv.man2) service manuals if exist.