Read Panasonic PT-MZ16K / PT-MZ13K / PT-MZ10K (serv.man2) Service Manual online
ADJ-8
SECTION 3 ADJUSTMENTS
<MZ16K/MZ13K/MZ10K>
1.4.4. Restore the backup adjusted data (after PCB replaced)
1. Start up service software [LogTool.exe] with a computer according to steps 1 - 4 of "1.4.3. Backup the adjusted data (be-
fore PCB exchange)" and connect it to the projector.
2. Restore the adjusted data by the following procedure.
① Select the projector name to send the data.
② Select a [Service] tab.
③ Check-mark [Replace A-Pwb] in "Data Restore".
④ Click [Send] button in "Data Restore".
3. Select the saved file and click [OPEN(O)] button.
4. Once the progress bar reaches the right side end and when the "Complete" dialog window appears, it is complete the writ-
ing.
5. Click [OK] button to close the window and quit the software.
Turn off the main switch and on again, and then check the projector operates normally.
③
④
①
②
Option selection of Data Restore
Option
Description
Replace Projector Wrighting the EEPROM data
Replace A-Pwb
Writing the Gamma/Uniformity data and
EEPROM data
Replace DG-Pwb
n/a
Replace User data Writing the uer setup data only
Repcale Gamma/
Repcale Gamma/
Unifomity
Writing the Gama/Uniformity data only
Click on the first or last page to see other PT-MZ16K / PT-MZ13K / PT-MZ10K (serv.man2) service manuals if exist.