PT-JW130GWE, PT-JW130GBE (serv.man2) - Panasonic Projector Service Manual (repair manual). Page 18

SECTION 1  SERVICE  INFORMATION

<PT-JW130>

1. SELF CHECK

・

Self-diagnosing information Displays.
 SELF CHEC

 MAIN  : 1.00.00   SUB : 1.00.00

←

Main & Sub microprocessor firmware version

 NETWORK : 1.00    FPGA:0x20

←

Network microprocessor & FPGA firmware version

 BALLAST : 10080

←

BALLAST firmware version

 OK  TEMP_INTR.    123/456

←

Internal air temperature (Celsius/Fahrenheit)

 OK  TEMP_DMD.    123/456

←

DMD temperature (Celsius/Fahrenheit)

 OK  TEMP_LD.    123/456

←

LD temperature (Celsius/Fahrenheit)

 OK  FAN 11

←

Fan condition (1: normal /0:stop)  From left, intake,power

 LIGHT    7h35m

←

Light source lighting cumulative time

 PHOSPHOR WHEEL : OK  COLOR WHEEL : OK

←

Phosphor wheel & Color wheel check

* If any error occurs, font of "OK" becomes red.

2. WHEEL SETTING

・

Color wheel and phosphor wheel turn phase manually adjustment.
Please do not usually change setting.

3. MODEL

・

Set this when the A-P.C.Board is replaced.
  * If you can copy EEPROM data from the old A-P.C.Board, this setting is unnecessary.
  * This model setting is changed after power restart.

4. FIRMWARE UPDATE

・

Update of firmware can be performed using SD card. 
Grayout will be canceled if SD card containing the file for update is inserted. 
Please refer to SECTION 3 (Software Update) for the procedure.

1. [SETUP] menu

・

The following items are added to an indication screen of the sub menu [STATUS].
1) Page 1/3

LIGHT TEMP.

Light source temperature (Celsius/Fahrenheit)

2) Page 2/3

FPGA VERSION

FPGA firmware version

BALLAST VERSION

BALLAST firmware version

BALLAST STATUS

Status of the LD1 - LD4 from left

0:Off, 1:On, 2:Synchronization signal abnormality (lit state), 3:Factory coordination abnormality (lit state),

4:Light source voltage error (off state), 5:Light source voltage error (off state), A:Light source power 20V failure (off state)

B:Light source driver reset occurrence (off state), C:Light source driver EEPROM error (off state)

3) Page 3/3

This page is added.
Each fan speed and temperature of each part will be displayed.

2. [DISPLAY OPTION] menu

・

[CUT OFF] menu is added.

Red(R), Green(G), Blue(B) color component is selected and display or non-display set.

3. [TEST PATTERN] menu

・

The following test patterns are added.

 "Whole red", "Whole green", "Whole blue", "LAMP"

0 x 1 1 1 1

INF - 9