ET-YFB200G - Panasonic Projector Service Manual (repair manual). Page 18

SOFTWARE UPDATE PROCEDURE

< YFB200G >

・

Update the software by connecting to a serial terminal or LAN terminal.

・

The update procedure via the LAN terminal connection is recommended for quick updating.

* Network software is LAN connection only
* DIGITAL LINK software is serial connection only

1. Computer : Use it for the transfer of software.
2. Communication cable

  LAN cable. (When connecting directly, use a cross cable)
  D-sub 9pin (male/female RS-232C straight)

3. Service Software : [MainSubNet Update Tool.exe] Download from the projector service Web (PASS). 
4. Microprocessor Software: Download the software file from the projector service Web (PASS) to the PC.
* Please prepare a projector or display with DVI-D input terminal.  (In order to confirm the setting of this unit.)

1. Check the settings of this device.

1) Select the menu [NETWORK] - [NETWORK STATUS], and check the IP address and take a note.
2) Set the IP address of computer to the same network group of this device.

1) Check the RS-232C settings (ID, Baudrate  and Parity) and take a note.

・

If you change the settings, return its settings to the original (customers) after work.

・

Set up your computer not to be standby or shutdown.

・

In the case of serial terminal connection, do not connect anything to the "DIGITAL LINK OUT" terminal.

2. Connect the device and the PC by using a communication cable.

f

LAN terminal connection example

f

Serial terminal connection example

・

Do not connect anything to the "DIGITAL LINK OUT" terminal.

LAN terminal connection

Serial terminal connection

LAN terminal connection

Serial terminal connection

Computer

Hub

LAN cable (straight)

LAN cable
(straight)

YFB200G

YFB200G

Computer

Communication cable

Plug for 3-pin 3.5 mm detachable

terminal block

18