ET-YFB200G - Panasonic Projector Service Manual (repair manual). Page 2

PREFACE

< YFB200G >

The service technician is required to read and follow the “Safety Precautions” and “Important Safety Notice” in this service manual.

Any unauthorized changes or modifications to this equipment will void the users authority to operate.

This device is using the P.C.Board which applies lead free solder.
Use lead free solder in servicing from the standpoint of antipollution for the global environment.
Notes:
  

・

 Lead free solder: Sn-Ag-Cu (tin, silver and copper) has a higher melting point (approx. 217°C) than standard solder. Typically the melting point

  ・ is 30~40 °C higher. When servicing, use a high temperature soldering iron with temperature limitation function and set it to 370 ± 10 °C.
  ・ Be precautious about lead free solder. Sn-Ag-Cu (tin, silver and copper) will tend to splash when heated too high (approx. 600°C or higher).
  ・ Use lead free solder for the P.C.Board (specified on it as “PbF”) which uses lead free solder. (When you unavoidably use lead solder, use lead
  ・ solder after removing lead free solder. Or be sure to heat the lead free solder until it melts completely, before applying lead solder.)
  ・ After soldering to double layered P.C.Boards, check the component side for excess solder which may flow onto the opposite side.

About the identification of the lead free solder P.C.Board.
  For the P.C.Board which applies lead free solder, the symbol as shown in the figure below is printed or stamped on the surface
  or the back of P.C.Board.

 

There are special components used in this equipment which are important for safety. These parts are marked by 7 in the schematic

  diagram, circuit board diagrams, exploded views and replacement parts list. It is essential that these critical parts should be replaced
  with manufacturer’s specified parts to prevent shock, fire, or other hazards. Do not modify the original design without permission of
  manufacturer.

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more
of the following measures:
  ・Reorient or relocate the receiving antenna.
  ・Increase the separation between the equipment and receiver.
  ・Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  ・Consult the dealer or an experienced radio/TV technician for help.

  

7

  This service information is designed for experienced repair technicians only and is not designed for use by the general public.
  It dose not contain warnings or cautions to advise non-technical individuals of potential dangers in attempting to service a product.
  Products powered by electricity should be serviced or repaired only by experienced professional technicians. Any attempt to service
  or repair the product or products dealt with in this service information by anyone else could result in serious injury or death.

2