Read Panasonic KX-MB2110RUW / KX-MB2130RUW / KX-MB2170RUW / KX-MB2117RUB / KX-MB2137RUB / KX-MB2177RUB Service Manual online
74
KX-MB2110RUW/ KX-MB2130RUW/ KX-MB2170RUW/ KX-MB2117RUB/ KX-MB2137RUB/ KX-MB2177RUB
6.18. SMPS (Switching Mode Power Supply) Section
The power supply board circuit generates 24Vdc and 12Vdc.
It also supplies AC voltage to the halogen heat lamp in the fuser unit.
The power supply board uses the switching regulator method.
It also supplies AC voltage to the halogen heat lamp in the fuser unit.
The power supply board uses the switching regulator method.
[Input Circuit]
The input current goes into the input rectifier circuit through the filter circuit.
The filter circuit decreases the noise voltage and the noise electric field strength.
The filter circuit decreases the noise voltage and the noise electric field strength.
[Rectifier Circuit]
The input circuit is rectified by D1 and charge C5 to make DC voltage.
Then it supplies power to the converter circuit.
Then it supplies power to the converter circuit.
[Kick-on Voltage Circuit]
Bias is applied to the Q1 gate via this circuit when the AC power is turned on and Q1 begins operating.
[Control Circuit and Error Detecting Circuit 1]
The control circuit detects the voltage that increased in an error detect circuit 1 and controls it to become the predetermined out-
put voltage.
This is shown as follows.
When the output voltage of the 24V circuit or 12V circuit increases, the current of the photo coupler PC1 increases, the pulse
width of the output control IC becomes narrower and the ON period of Q1 becomes shorter.
put voltage.
This is shown as follows.
When the output voltage of the 24V circuit or 12V circuit increases, the current of the photo coupler PC1 increases, the pulse
width of the output control IC becomes narrower and the ON period of Q1 becomes shorter.
[Over Current Protection (O.C.P)]
The highest drain current of Q1 is limited by a over current circuit. The 24V or 12V output is limited by this circuit.
[Over Voltage Protection (O.V.P)]
If the 24V or 12V output increases because the error detecting circuit or control circuit is broken, Control circuit will recognize
this signal and output becomes 0V. D104 also prevent over voltage.
this signal and output becomes 0V. D104 also prevent over voltage.
Dummy load method (to quickly check the power supply output).
See the Low Voltage Power Supply Board (SMPS Board)Section.
Click on the first or last page to see other KX-MB2110RUW / KX-MB2130RUW / KX-MB2170RUW / KX-MB2117RUB / KX-MB2137RUB / KX-MB2177RUB service manuals if exist.