Read Panasonic KX-MB2110RUW / KX-MB2130RUW / KX-MB2170RUW / KX-MB2117RUB / KX-MB2137RUB / KX-MB2177RUB Service Manual online
37
KX-MB2110RUW/ KX-MB2130RUW/ KX-MB2170RUW/ KX-MB2117RUB/ KX-MB2137RUB/ KX-MB2177RUB
6.5.
ITS (Integrated telephone System) and Monitor Section
( Fax supported models only )
6.5.1.
General
The general ITS operation is performed by IC203 which has a handset circuit. The alarm tone, the key tone, and the beep are
output from Soc IC300.
output from Soc IC300.
6.5.1.1.
Telephone Monitor
1. Function
This is the function when you are not holding the handset and can hear the caller’s voice from the line.
2. Circuit Operation
(Telephone Monitor Signal Path)
Signals received from the telephone line are output through at the speaker via the following path.
Signals received from the telephone line are output through at the speaker via the following path.
3. Signal Path
Refer to Check Sheet for Signal Route of MONITER RX (P.170).
6.5.1.2.
Monitor Circuit
1. Function
This circuit monitors various tones, such as (1) DTMF tone, (2) Alarm/Beep/Key tone/Bell.
2. Signal Path
a. DTMF MONITOR
(Speaker Operation)
Refer to Check Sheet for Signal Route of DTMF Monitor (Speaker) (P.170).
(Handset Operation)
Refer to Check Sheet for Signal Route of DTMF Monitor (Handset) (P.170).
Refer to Check Sheet for Signal Route of DTMF Monitor (Speaker) (P.170).
(Handset Operation)
Refer to Check Sheet for Signal Route of DTMF Monitor (Handset) (P.170).
b. ALARM/BEEP/KEY TONE/BELL
Refer to Check Sheet for Signal Route of Ringing/Alarm/Beep/Key tone (P.170).
6.5.1.3.
TAM Interface Section
1. Function
When TAM is connected to this unit, the unit receives documents for FAX calls or the external TAM records a voice message
automatically.
automatically.
2. Circuit Operation
The TAM INTERFACE circuit consists of Soc(IC300) to detect the other party CNG signal, and RLY100 to separate EXT.TAM.
a. CNG signal detection circuit
The CNG signal from the other party’s FAX is detected in Soc IC300
(Signal path)
Refer to Check Sheet for Signal Route of CNG/DTMF detection (P.170).
(Signal path)
Refer to Check Sheet for Signal Route of CNG/DTMF detection (P.170).
b. Remote receiving
This is the parallel-connected DTMF signal for the TEL or EXT.TEL mode between T and R. When the other party is a
FAX, the unit switches to FAX receiving.
(Signal Path)
Refer to Check Sheet for Signal Route of DTMF detection (ON-Hook) (P.170).
FAX, the unit switches to FAX receiving.
(Signal Path)
Refer to Check Sheet for Signal Route of DTMF detection (ON-Hook) (P.170).
Click on the first or last page to see other KX-MB2110RUW / KX-MB2130RUW / KX-MB2170RUW / KX-MB2117RUB / KX-MB2137RUB / KX-MB2177RUB service manuals if exist.