Read Panasonic CF-Y4HWPZZ Service Manual online
2.2.4. Removing the LCD Block
·
Preparation: Make sure that the steps in sections 2.2.1
to 2.2.3 have been taken first.
(The entire unit is now standing upright with the LCD
Block open at a 90-degree angle.)
to 2.2.3 have been taken first.
(The entire unit is now standing upright with the LCD
Block open at a 90-degree angle.)
1. Disconnect the LCD Cable from the connector (CN8) on the
Main Board.
2. Disconnect the Inverter Cable from the connector (CN11).
3. Remove the LCD Hook, lift the front end of the Top Case
3. Remove the LCD Hook, lift the front end of the Top Case
Ass’y using the hinge as a fulcrum, and move the LCD
Block from the Top Case Ass’y in the direction of the arrow
to remove it.
Block from the Top Case Ass’y in the direction of the arrow
to remove it.
Conductive
Cloth
Cloth
Hinge
LCD Block
Top Case Ass'y
CN8
CN11
*The Conductive Cloth cannot be re-used.
Use a new one instead.
2.2.5. Removing the HDD
·
Preparation: Make sure that the steps in sections 2.2.1
to 2.2.4 have been taken first.
to 2.2.4 have been taken first.
1. Remove the HDD by lifting it and disconnecting the HDD
Flexible Connector.
HDD
HDD Case
HDD Flexible Connector
Bottom Case Ass'y
FPC
* Take care to avoid bending the connecting pins on the
HDD side when disconnecting the HDD Flexible Connecor.
2.2.6. Removing the MDC Modem Board
·
Preparation: Make sure that the steps in sections 2.2.1
to 2.2.5 have been taken first.
to 2.2.5 have been taken first.
1. Remove the two Screws (K).
Screw (K): DXHM0056ZA
2. Disconnect the MDC Board Block from the Pad/HDD FPC
connector.
3. Peel off the tape, disconnect the Modem Cable, and
remove the Modem Jack.
Screw(K)
Modem Cable
MDC Modem Board
Tape
Modem Jack
Top Case Ass’y
2.2.7. Removing the Power SW & Jack
Board
·
Preparation: Make sure that the steps in sections 2.2.1
to 2.2.5 have been taken first.
to 2.2.5 have been taken first.
1. Remove the two Screws (L), and remove the HDD Angle.
Screw (L): DXHM0056ZA
2. Disconnect the FPC (HDD/Angle) from the connector
(CN910).
3. Remove the Screw (M), and remove the LED/Power Board.
Screw (M):DXHM0056ZA
CN910
Screw (M)
Open SW
& Jack PCB
& Jack PCB
Power Knob
Jack HDD Angle
Screw (L)
2-4
Click on the first or last page to see other CF-Y4HWPZZ service manuals if exist.