Read Panasonic CF-T4HWETZBM Service Manual online
2. Attachment preparation of Key Board
2-1. Putting of Heat Sheet KB Large
Touch the KB hole
Touch the KB hole
Inclination is set
to 0.5mm or less.
to 0.5mm or less.
Inclination is set
to 0.5mm or less.
to 0.5mm or less.
2-2. Putting of tape
0
1mm
0
1mm
8
1mm
0.5
1.5mm
0.5
1.5mm
Tape(KBD)
KeyBoard exterior and FPC are parallel.
(KBD)
0
0.5mm
3. Screw tightening of bottom case (1)
The keyboard is inserted, and after the keyboard hooks are inserted in order of a and b while holding the keyboard, the screw
tightening is done in the following order.
tightening is done in the following order.
Note:The sheet metal must not run aground on the rib (Refer to the figure below).
2-1. DXHM0039ZA(D:N5) is tightened. No.1 to No.7
2-2. DXHM0057ZA(G:N7) is tightened. No.8 to No.12
Keyboard
Hook
Hook
Top Case
Top Case Rib
OK
NG
Assembly reference chart
Screw(G)
Screw(G)
Screw(D)
Screw(D)
Screw(D)
Screw(D)
Screw(G)
Screw(G)
Screw(G)
Screw(D)
Screw(D)
Screw(D)
Keyboard Hook a
Keyboard Hook b
41
Click on the first or last page to see other CF-T4HWETZBM service manuals if exist.