UE-608040 - Panasonic Other Service Manuals Service Manual (repair manual). Page 9

9

This product (Wireless Kit) is installed on the left-upper side of elite Panaboard. Follow the instructions below to install this product.

This is a sophisticated piece of equipment, which somewhat depends on the surrounding conditions for optimum operation.
Attention to the following will result in more reliable and quality performance.

  (Where NOT to Use the Wireless Kit)
     (1) Do not use the Wireless Kit near other wireless devices.
         The following equipment may use radio waves in the same band as the Wireless Kit. When the Wireless Kit is
         used near these devices, radio wave interference may make communication impossible, or the communication
         speed may become slower.
                 (a) Microwave ovens etc.                 
                 (b) Industrial, chemical and medical equipment, etc.
                 (c) In-plant radio stations for identifying moving objects such as those used in factory manufacturing lines, etc.
                 (d) Designated low-power radio stations 
                       When the Wireless Kit is used near devices that emit radio waves at a frequency between 2,000 to 2,700 MHz,
                       sound from elite Panaboard might be interrupted

     (2) If possible, avoid the use of cellular phones, TV sets or radios near the Wireless Kit
         Cellular phones, TV sets, radios and similar devices use different radio bands from the Wireless Kit, so there is
         no effect on wireless communication or the transmission and reception of these devices. However, radio waves from
         the Wireless Kit may produce audio or video noise.

     (3) Wireless communication radio waves cannot penetrate steel reinforcements, metal, concrete, etc.
        Communication is possible through walls and floors made from materials such as wood and glass
        (except glass containing wire mesh), but not through walls and floors made from steel reinforcements, metal, concrete, etc.

     (4) Avoid using the Wireless Kit in locations prone to static electricity.
        If you use the Wireless Kit where a lot of static energy is generated, such as a on a carpet, communications may be
       affected. In that case, you must remove the static energy or source of the noise, and reconnect the wireless LAN.
       In some cases the wireless LAN may be disconnected completely, and in this case you must turn off the elite
       Panaboard and then turn it back on again.

     (5) Avoid using the Wireless Kit outside the country
        It is forbidden to take the Wireless Kit outside the country or region where you purchased it, so use it only in that
       country or region. Also, note that different countries and regions have restrictions on the channels and frequencies
       at which you can use the wireless LAN.

     (6) Avoid using the Wireless Kit in areas with the following conditions 
           • High temperature and humidity or low temperature and low humidity
           • Direct exposure to sunlight
           • Direct exposure to air conditioners, or close to heater ducts

Before installing this product, make sure to secure the space for installing this product, referring to Sec.2.6 "External Dimensions".